MX29LV800CBMC-45 데이터 시트보기 (PDF) - Macronix International

부품명

상세내역

제조사

MX29LV800CBMC-45

8M-BIT [1Mx8/512K x16] CMOS SINGLE VOLTAGE 3V ONLY FLASH MEMORY

Macronix International 

MX29LV800C T/B

TABLE 7. SILICON ID CODE

Pins

Manufacture code

Device code

for MX29LV800CT

Device code

for MX29LV800CB

Sector Protection

Verification

A0

Word VIL

Byte VIL

Word VIH

Byte VIH

Word VIH

Byte VIH

Word X

Byte X

A1 Q15~Q8 Q7 Q6 Q5

VIL 00H 1 1 0

VIL X

110

VIL 22H 1 1 0

VIL X

110

VIL 22H 0 1 0

VIL X

010

VIH X

000

VIH X

000

Q4 Q3 Q2 Q1 Q0 Code (Hex)

0 0 0 1 0 00C2H

0 0 0 1 0 C2H

1 1 0 1 0 22DAH

1 1 0 1 0 DAH

1 1 0 1 1 225BH

1 1 0 1 1 5BH

0 0 0 0 1 01H (Protected)

0 0 0 0 0 00H (Unprotected)

READING ARRAY DATA

The device is automatically set to reading array data

after device power-up. No commands are required to re-

trieve data. The device is also ready to read array data

after completing an Automatic Program or Automatic

Erase algorithm.

After the device accepts an Erase Suspend command,

the device enters the Erase Suspend mode. The sys-

tem can read array data using the standard read tim-

ings, except that if it reads at an address within erase-

suspended sectors, the device outputs status data. Af-

ter completing a programming operation in the Erase

Suspend mode, the system may once again read array

data with the same exception. See "Erase Suspend/Erase

Resume Commands" for more information on this mode.

The system must issue the reset command to re-en-

able the device for reading array data if Q5 goes high, or

while in the autoselect mode. See the "Reset Command"

section, next.

RESET COMMAND

Writing the reset command to the device resets the de-

vice to reading array data. Address bits are don't care for

this command.

The reset command may be written between the se-

quence cycles in an erase command sequence before

erasing begins. This resets the device to reading array

data. Once erasure begins, however, the device ignores

reset commands until the operation is complete.

The reset command may be written between the se-

quence cycles in a program command sequence before

programming begins. This resets the device to reading

array data (also applies to programming in Erase Sus-

pend mode). Once programming begins, however, the

device ignores reset commands until the operation is

complete.

The reset command may be written between the se-

quence cycles in an SILICON ID READ command se-

quence. Once in the SILICON ID READ mode, the reset

command must be written to return to reading array data

(also applies to SILICON ID READ during Erase Sus-

pend).

If Q5 goes high during a program or erase operation, writ-

ing the reset command returns the device to reading ar-

ray data (also applies during Erase Suspend).

P/N:PM1183

REV. 1.4, APR. 24, 2006

15

Share Link: