NCV7356(2004) 데이터 시트보기 (PDF) - ON Semiconductor
부품명
상세내역
제조사
NCV7356 Datasheet PDF : 14 Pages
| |||
NCV7356
Advance Information
Single Wire CAN Transceiver
The NCV7356 is a physical layer device for a single wire data link
capable of operating with various Carrier Sense Multiple Access
with Collision Resolution (CSMA/CR) protocols such as the Bosch
Controller Area Network (CAN) version 2.0. This serial data link
network is intended for use in applications where high data rate is not
required and a lower data rate can achieve cost reductions in both the
physical media components and in the microprocessor and/or
dedicated logic devices which use the network.
The network shall be able to operate in either the normal data rate
mode or a high−speed data download mode for assembly line and
service data transfer operations. The high−speed mode is only
intended to be operational when the bus is attached to an off−board
service node. This node shall provide temporary bus electrical loads
which facilitate higher speed operation. Such temporary loads should
be removed when not performing download operations.
The bit rate for normal communications is typically 33 kbit/s, for
high−speed transmissions like described above a typical bit rate of
83 kbit/s is recommended. The NCV7356 is designed in accordance
to the Single Wire CAN Physical Layer Specification GMW3089
V2.3 and supports many additional features like undervoltage
lockout, timeout for faulty blocked input signals, output blanking
time in case of bus ringing and a very low sleep mode current.
Features
• Fully Compatible with J2411 Single Wire CAN Specification
• 60 mA (max) Sleep Mode Current
• Operating Voltage Range 5.0 to 27 V
• Up to 100 kbps High−Speed Transmission Mode
• Up to 40 kbps Bus Speed
• Selective BUS Wake−Up
• Logic Inputs Compatible with 3.3 V and 5 V Supply Systems
• Control Pin for External Voltage Regulators
• Standby to Sleep Mode Timeout
• Low RFI Due to Output Wave Shaping
• Fully Integrated Receiver Filter
• Bus Terminals Proof Against Short−Circuits and Transients
• Loss of Ground Protection
• Protection Against Load Dump, Jump Start
• Thermal Overload and Short Circuit Protection
• ESD Protection of 4.0 kV on CAN Pin (2.0 kV on Any Other Pin)
• Undervoltage Lock Out
• Bus Dominant Timeout Feature
• NCV Prefix for Automotive and Other Applications Requiring Site
and Change Control
This document contains information on a new product. Specifications and information
herein are subject to change without notice.
http://onsemi.com
14
1
14
SO−14
D SUFFIX
CASE 751A
1
MARKING
DIAGRAM
NCV7356
AWLYWW
A = Assembly Location
WL = Wafer Lot
Y = Year
WW = Work Week
PIN CONNECTIONS
GND 1
TxD 2
MODE0 3
MODE1 4
RxD 5
NC 6
GND 7
14 GND
13 NC
12 CANH
11 LOAD
10 VBAT
9 INH
8 GND
(Top View)
ORDERING INFORMATION
Device
Package
Shipping†
NCV7356D
SOIC−14
55 Units / Rail
NCV7356DR2 SOIC−14 1000 Tape & Reel
†For information on tape and reel specifications,
including part orientation and tape sizes, please
refer to our Tape and Reel Packaging Specification
Brochure, BRD8011/D.
© Semiconductor Components Industries, LLC, 2004
1
September, 2004 − Rev. P2
Publication Order Number:
NCV7356/D
Share Link: 