NCV7361 데이터 시트보기 (PDF) - ON Semiconductor
부품명
상세내역
제조사
NCV7361 Datasheet PDF : 28 Pages
| |||
NCV7361A
ELECTRICAL SPECIFICATIONS
All voltages are referenced to ground (GND). Positive
currents flow into the IC.
The maximum ratings (in accordance with IEC 134)
given in the table below are limiting values that do not lead
to a permanent damage of the device but exceeding any of
these limits may do so. Long term exposure to limiting
values may affect the reliability of the device. Correct
operating of the device can’t be guaranteed if any of these
limits are exceeded.
OPERATING CONDITIONS
Characteristic
Supply Voltage
Operating Ambient Temperature
Junction Temperature
Symbol
VSUP
TA
TJ
Min
Max
Unit
5.25
18
V
−40
+125
°C
−
+150
°C
MAXIMUM RATINGS
Rating
Symbol
Condition
Min
Max Unit
VSUP
BUS
Difference VSUP−VOUT
EN
VSUP
VBUS
VSUP−VOUT
VINEN
−
T v 500 ms
−
T v 500 ms
−
−
−1.0
30
V
−
40
−24
30
V
−
40
−0.3
40
V
−0.3
VSUP +
V
0.3
TxD, RxD, RESET
VIN
−
−0.3
VOUT +
V
0.3
EN, TxD, RxD, RESET
IIN
−
−25
25
mA
Short Circuit of Pin VSUP and VOUT
IINSH
−
−500
500
mA
ESD Capability TxD Pin
ESDBUSHB Human Body Model, 100 pF via 1.5 kW −1.0
1.0
kV
ESD Capability on All Other Pins
ESDHB Human Body Model, 100 pF via 1.5 kW −2.0
2.0
kV
Junction Temperature
TJ
−
−
150
°C
Storage Temperature
TSTG
−
−55
150
°C
Lead Temperature Soldering
Reflow: (SMD styles only)
Tsld
60 second maximum above 183°C
−
240 peak °C
−5°C/+0°C allowable conditions
Maximum ratings are those values beyond which device damage can occur. Maximum ratings applied to the device are individual stress limit values
(not normal operating conditions) and are not valid simultaneously. If these limits are exceeded, device functional operation is not implied, damage
may occur and reliability may be affected.
THERMAL RATINGS
Parameter
Test Conditions Typical Value
SO−8 Package
Min−Pad Board (Note 1)
1.0 in Pad Board (Note 2)
Junction−to−Tab (psi−JL2, YJL2) (Note 3)
48
43
Junction−to−Ambient (RqJA, qJA)
183
120
1. 1 oz copper, 54 mm2 copper area, 0.062” thick FR4.
2. 1 oz copper, 714 mm2 copper area, 0.062” thick FR4.
3. psi−JL2 temperature was made at foot of lead #2.
Units
°C/W
°C/W
http://onsemi.com
3
Share Link: 