NJM3517 데이터 시트보기 (PDF) - Japan Radio Corporation
부품명
상세내역
제조사
NJM3517 Datasheet PDF : 12 Pages
| |||
NJM3517
DIR H
INH L
HSM H
STEP P
OB L
LB P
PB1 P
PB2 P
PA1 P
PA2 P
LA P
OA L
DIR L
INT L
HSM H
STEP P
OB L
LB P
PB1 P
PB2 P
PA1 P
PA2 P
LA P
OA L
Figure 7. Full-step mode, forward. 4-step sequence. Gray-code Figure 8. Full-step mode, reverse. 4-step sequence. Gray-
+90° phase shift.
code -90° phase shift.
DIR H
INH L
HSM L
STEP P
C
OB P
LB P
PB1 P
PB2 P
PA1 P
PA2 P
LA P
OA P
DIR L
INH L
HSM L
STEP P
C
OB P
LB P
PB1 P
PB2 P
PA1 P
PA2 P
LA P
OA P
Figure 9. Half-step mode, forward. 8-step sequence.
Figure 10. Half-step mode, reverse. 8-step sequence.
DIR L
INH H
HSM L
STEP P
C
OB P
LB P
PB1 H
PB2 H
PA1 H
PA2 H
LA P
OA P
Figure 11. Half-step mode, inhibit.
s APPLICATIONS INFORMATION
Logic inputs
If any of the logic inputs are left open, the circuit will treat it as a high-level input. Unused inputs should be con-
nected to proper voltage levels in order to get the highest noise immunity.
Phase outputs
Phase outputs use a current-sinking method to drive the windings in a unipolar way. A common resistor in the
center tap will limit the maximum motor current.
Fast free-wheeling diodes must be used to protect output transistors from inductive spikes.
Series diodes in V supply, prevent V voltage from shorting through the V power supply. However, these
MM
SS
MM
may be omitted if no bi-level is used. The V pin must not be connected to a lower voltage than V , but can be left
SS
MM
unconnected.
Zero outputs
ØA and ØB, “zero A” and “zero B,” are open-collector outputs, which go high when the corresponding phase output
is inhibited by the half-step-mode circuitry. A pull-up resistor should be used and connected to a suitable supply
voltage (5 kohms for 5V logic). See “Bipolar phase logic output.”
Interference
To avoid interference problems, a good idea is to route separate ground leads to each power supply, where the
only common point is at the NJM3517’s GND pin. Decoupling of VSS and VMM will improve performance. A 5 kohm
pull-up resistor at logic inputs will improve level definitions, especially when driven by open-collector outputs.
Share Link: 