ST24C08B1TR(2002) 데이터 시트보기 (PDF) - STMicroelectronics

부품명

상세내역

제조사

ST24C08B1TR
(Rev.:2002)

8 Kbit Serial I2C Bus EEPROM with User-Defined Block Write Protection

STMicroelectronics 

ST24/25C08, ST24/25W08

Figure 10. Write Modes Sequence with Write Control = 1 (ST24/25W08)

WC

BYTE WRITE

ACK

ACK

NO ACK

DEV SEL

BYTE ADDR

DATA IN

R/W

WC

PAGE WRITE

WC (cont'd)

PAGE WRITE

(cont'd)

ACK

ACK

NO ACK

DEV SEL

BYTE ADDR DATA IN 1

DATA IN 2

R/W

NO ACK

NO ACK

DATA IN N

AI01161B

Read Operations

Read operations are independent of the state of the

MODE pin. On delivery, the memory content is set

at all "1’s" (or FFh).

Current Address Read. The memory has an inter-

nal byte address counter. Each time a byte is read,

this counter is incremented. For the Current Ad-

dress Read mode, following a START condition,

the master sends a memory address with the RW

bit set to ’1’. The memory acknowledges this and

outputs the byte addressed by the internal byte

address counter. This counter is then incremented.

The master does NOT acknowledge the byte out-

put, but terminates the transfer with a STOP con-

dition.

Random Address Read. A dummy write is per-

formed to load the address into the address counter

(see Figure 11). This is followed by another START

condition from the master and the byte address is

repeated with the RW bit set to ’1’. The memory

acknowledges this and outputs the byte ad-

dressed. The master have to NOT acknowledge

the byte output, but terminates the transfer with a

STOP condition.

Sequential Read. This mode can be initiated with

either a Current Address Read or a Random Ad-

dress Read. However, in this case the master

DOES acknowledge the data byte output and the

memory continues to output the next byte in se-

quence. To terminate the stream of bytes, the

11/16

Share Link: