PC357 데이터 시트보기 (PDF) - Sharp Electronics

부품명

상세내역

제조사

PC357

PHOTOCOUPLER

Sharp Electronics 

SHARP CORPORATION

ED-97136

1 ~September 8, 1997

MODEL No.

1 PAGE

PC357NT

lO/ 12

6.2 Package specifications

6.2.1 Taping conditions

(1) Tape structure and Dimensions (Refer to the attached sheet, Page 10)

The tape shall have a structure in which a cover tape is sealed heat-pressed on

the carrier tape of protect against static electricity.

(2) Reel structure and Dimensions (Refer to the attached sheet, Page 11)

The taping reel shah be of plastic with its dimensions

as shown in the attached drawing.

(31 Direction of product insertion (Refer to the attached sheet, Page 11)

Product direction in carrier tape shall direct to the anode mark at the

hole side on the tape.

(4) Joint of tape

The cover tape and carrier tape in one reel shall be jointless.

(5) The way to repair taped failure devices

The way to repair taped failure devices cut a bottom of carrier tape with a cutter, and

after replacing to good devices, the cut portion shall be sealed with adhesive tape.

6.2.2 Adhesiveness of cover tape

l The exfoliation force between carrier tape and cover tape shall be

0.2N to 0.7N for the angle from 160’ to 180’ .

6.2.3 Rolling method and quantity

l Wind the tape back on the reel so that the cover tape will be outside the tape.

Attach more than 20cm of blank tape to the trailer and the leader of the tape

and fuc the both ends with adhesive tape. One reel shall contain 750~~s.

6.2.4 Marking

* The outer packaging case shall be marked with following information.

* Model No. * Number of pieces delivered * Production date

6.2.5 Storage condition

9 Taped products shall be stored at the temperature between

5 and 30°C and the humidities lower than 70%RH.

6.2.6 Safety protection during shipping

l There shall be no deformation of component or degradation of electrical

characteristics due to shipping.

Share Link: