PCF2129T 데이터 시트보기 (PDF) - NXP Semiconductors.

부품명

상세내역

제조사

PCF2129T

Accurate RTC with integrated quartz crystal for industrial

NXP Semiconductors. 

NXP Semiconductors

PCF2129T

Accurate RTC with integrated quartz crystal for industrial

8. Functional description

The PCF2129T is a Real Time Clock (RTC) and calendar with an on-chip Temperature

Compensated Crystal (Xtal) Oscillator (TCXO) and a 32.768 kHz quartz crystal integrated

into the same package (see Section 8.3.2).

Address and data are transferred by a selectable 400 kHz Fast-mode I2C-bus or a 3 line

SPI-bus with separate data input and output (see Section 9). The maximum speed of the

SPI-bus is 6.5 Mbit/s.

The PCF2129T has a backup battery input pin and backup battery switch-over circuit

which monitors the main power supply. The backup battery switch-over circuit

automatically switches to the backup battery when a power failure condition is detected

(see Section 8.5.1). Accurate timekeeping is maintained even when the main power

supply is interrupted.

A battery low detection circuit monitors the status of the battery (see Section 8.5.3). When

the battery voltage drops below a certain threshold value, a flag is set to indicate that the

battery must be replaced soon. This ensures the integrity of the data during periods of

battery backup.

8.1 Register overview

The PCF2129T contains an auto-incrementing address register: the built-in address

register will increment automatically after each read or write of a data byte up to the

register 1Bh. After register 1Bh, the auto-incrementing will wrap around to address 00h

(see Figure 3).

address register

00h

01h

02h

03h

...

19h

1Ah

1Bh

auto-increment

wrap around

001aaj398

Fig 3. Handling address registers

• The first three registers (memory address 00h, 01h, and 02h) are used as control

registers (see Section 8.2).

• The memory addresses 03h through to 09h are used as counters for the clock

function (seconds up to years). The date is automatically adjusted for months with

fewer than 31 days, including corrections for leap years. The clock can operate in

12-hour mode with an AM/PM indication or in 24-hour mode (see Section 8.8).

• The registers at addresses 0Ah through 0Eh define the alarm function. It can be

selected that an interrupt is generated when an alarm event occurs (see Section 8.9).

PCF2129T

Product data sheet

All information provided in this document is subject to legal disclaimers.

Rev. 3 — 12 February 2013

© NXP B.V. 2013. All rights reserved.

5 of 73

Share Link: