PSB2134 데이터 시트보기 (PDF) - Siemens AG
부품명
상세내역
제조사
PSB2134 Datasheet PDF : 95 Pages
| |||
PSB 2132
PSB 2134
Overview
1
Overview
The Signal Processing Codec Filter for terminal applications PSB 2132/4 SICOFI2/4-TE
is a special derivative of the SIEMENS programmable codec-filter-IC family designed for
terminal applications featuring two or four POTS interfaces.
It can be directly connected to the IOM-2 interface in terminal mode running at 1.536
MHz clock rate. PCM data is transfered using the bit clock signal at 768 kHz.
Programming of internal registers is done via the serial microcontroller interface.
Only two external capacitors per channel are needed to complete the functionality of the
PSB 2132/4. The internal level accuracy is based on a very accurate bandgap reference.
The frequency behaviour is mainly determined by digital filters, which do not have any
fluctuations. As a result of the new ADC- and DAC- concepts linearity is only limited by
second order parasitic effects. Although the device works only from one single 5 V
supply there is a very good dynamic range available.
The PSB 2132/4 is a DSP based codec which allows the integration of filters and tone
generators besides the regular A- or u-law conversion. In addition it integrates I/O
extentions to the microcontroller and provides the necessary I/O pins to control the SLIC
or discrete SLIC replacement. Interrupts are generated to the microcontroller if changes
(e.g. Off-Hook detection) have been occured. The PSB 2132/4 provides a ring frequency
output pin. This pin has a programmable clock frequency to meet the European and US
ringing frequency requirements using only one external divider.
The IOM-2 data lines DU and DD can both be used for transmitting or receiving voice
data. The position of each receive and transmit timeslot is programmable. Internal
communication between analog ports is supported by programming each channel to the
same timeslot but reversing the data lines. Thus the transmitted PCM data is transmitted
by one port and received by the second port via the same timeslot. An additional IC for
switch matrix is eliminated.
The PSB 2132/4 is specially of interest for applications, which need to serve different
country specific characteristics on the POTS interface. Since all filters are
programmable, adaptation to these country specific requirements may be done only by
software parameters using the same hardware.
Semiconductor Group
5
09.97
Share Link: 