RE46C141 데이터 시트보기 (PDF) - R and E International, Inc.

부품명

상세내역

제조사

RE46C141

CMOS Photoelectric Smoke Detector ASIC with Interconnect

R and E International, Inc. 

RE46C141

CMOS Photoelectric Smoke Detector ASIC with Interconnect

Product Specification

R&E International

PIN#

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

PIN NAME

C1

C2

DETECT

STROBE

VDD

IRED

IO

HB

HS

FEED

LED

COSC

ROSC

VSS

LBSET

TEST

PIN DESCRIPTIONS

DESCRIPTION

The capacitor connected to this pin sets the photo amplifier gain (high) for the

push-to-test and chamber sensitivity test. The size of this capacitor will depend

on the chamber background reflections. A=1+(C1/10) where C1 is in pF. The

gain should be <10000.

The capacitor connected to this pin sets the photo amplifier gain (normal) during

standby. The value of this capacitor will depend on the smoke sensitivity

required. A=1+(C2/10) where C2 is in pF.

Positive input to the photo amplifier. This input is normally connected to the

cathode of an external photo diode operated at zero bias.

Regulated output voltage of VDD-5 which is active during a test for smoke. This

output is the negative side of the photo amplifier circuitry.

Connect to the positive supply voltage

Provides a regulated pulsed output voltage pre-driver for the infrared emitter.

This output usually drives the base of an NPN transistor.

This bidirectional pin provides the capability to interconnect many detectors in a

single system. This pin has an internal pull-down device.

This pin is connected to the metal electrode of a piezoelectric transducer.

HS is a complementary output to HB and connects to the ceramic electrode of

the piezoelectric transducer.

Usually connected to the feedback electrode through a current limiting resistor. If

not used this pin must be connected to VDD or VSS.

Open drain NMOS output used to drive a visible LED.

A capacitor connected to this pin with a parallel resistor sets the internal clock

low time which is approximately the clock period.

A resistor between this pin and pin 12 (COSC) sets the internal clock high time.

This also sets the IRED pulse width (100-200uS).

Connect to the negative supply voltage.

This input is connected to a VDD reference voltage to set the low battery

warning voltage.

This input is used to invoke two test modes. This input has an internal pull-down.

Telephone 610.992.0727

Facsimile 610.992.0734

E-mail: rande@randeint.com

Page 6 of 12

DS-RE46C141-121806

This datasheet contains PROPRIETARY and CONFIDENTIAL information.

Share Link: