RF2422 데이터 시트보기 (PDF) - RF Micro Devices
부품명
상세내역
제조사
RF2422 Datasheet PDF : 6 Pages
| |||
RF2422
Pin Function Description
Interface Schematic
1
I REF
Reference voltage for the I mixer. This voltage should be the same as
Q SIG
the DC voltage supplied to the I SIG pin. A voltage of 3.0V is recom-
Q REF
mended. The SIG and REF inputs are inputs of a differential amplifier.
100Ω
100Ω
Therefore the REF and SIG inputs are interchangeable. If swapping the
I SIG and I REF pins, the Q SIG and Q REF also need to be swapped
to maintain the correct phase. It is also possible to drive the SIG and
REF inputs in a balanced mode. This will increase the gain.
425Ω 425Ω
2
Q REF
Reference voltage for the Q mixer. This voltage should be the same as
Q SIG
the DC voltage supplied to the Q SIG pin. A voltage of 3.0V is recom-
mended.
100Ω
Q REF
100Ω
425Ω
425Ω
5
3
GND2
Ground connection of the LO phase shift network. This pin should be
connected directly to the ground plane.
4
GND2
Same as pin 3.
5
GND2
Same as pin 3.
6
LO
The input of the phase shifting network. This pin has an internal DC-
blocking capacitor. At frequencies higher than 2GHz this port is well-
LO
matched to 50Ω. This port is voltage driven so matching at lower fre-
quencies is not required.
7
VCC1
Power supply for all circuits except the RF output stage. An external
capacitor is needed if no other low frequency bypass capacitor is
nearby.
8
PD
Power Down control. When this pin is "low", all circuits are shut off. A
"low" is typically 1.2V or less at room temperature.When this pin is
VCC
"high" (VCC), all circuits are operating normally. If PD is below VCC, out-
put power and performance will be degraded. Operating in this region
200 Ω
PD
is not recommended, although it might be useful in some applications
where power control is required.
9
RF OUT This is the 50Ω RF Output. This pin has an internal DC-blocking capac-
itor. At frequencies higher than 2GHz this port is well-matched. Typical
impedances at lower frequencies are: 24-j30 Ω @ 1GHz, 27-j10 Ω @
1.4GHz, 31-j3 Ω @ 1.8GHz. At those frequencies, external matching
may be needed to optimize output power.
RF OUT
10
GND3
Ground connection for the RF output stage. This pin should be con-
nected directly to the ground plane.
11
VCC2
Power supply for the RF Output amplifier. An external capacitor is
needed if no other low frequency bypass capacitor is near by.
12
GND1
Ground connection for the LO and baseband amplifiers, and for the
mixers. This pin should be connected directly to the ground plane.
13
GND1
Same as pin 12.
14
GND1
Same as pin 12.
15
Q SIG
Baseband input to the Q mixer. This pin is DC-coupled. Maximum out- See pin 2.
put power is obtained when the input signal has a peak to peak ampli-
tude of 2V. The recommended DC level for this pin is 3.0V. The peak
minimum voltage on this pin (VREF - peak modulation amplitude)
should never drop below 2.0V. The peak maximum voltage on this pin
(VREF + peak modulation amplitude) should never exceed 4.0V.
Rev A5 010817
5-31
Share Link: 