S6A0072 데이터 시트보기 (PDF) - Samsung

부품명

상세내역

제조사

S6A0072

16COM/40SEG DOT MATRIX LCD CONTROLLER & DRIVER

Samsung 

S6A0072

16COM/40SEG DOT MATRIX LCD CONTROLLER & DRIVER

FUNCTION DESCRIPTION

SYSTEM INTERFACE

This chip consists of two kinds of interface type with MPU: 4-bit bus and 8-bit bus. 4-bit bus and 8-bit bus is

selected by DL bit of function set in the instruction register. During read or write operation, two 8-bit registers are

used. One is the data register (DR), the other is the instruction register (IR). The data register (DR) is used as a

temporary data storage place for being written into or read from DDRAM/CGRAM, target RAM is selected by

RAM address setting instruction. Each internal operation, reading from or writing into RAM, is done automatically.

Thus, after MPU reads DR data, the data in the next DDRAM/CGRAM address is transferred into DR

automatically. Also after MPU writes data to DR, the data in DR is transferred into DDRAM/CGRAM

automatically. The Instruction register (IR) is used only to store instruction code transferred from MPU. MPU

cannot read data from instruction register. The register selection depends on RS input pin setting in both 4-bit bus

mode.

Table 1. Various Kinds Of Operations According to RS and R/W Bits

RS

R/W

Operation

0

0

Instruction write operation (MPU writes Instruction code into IR)

0

1

Read busy flag (DB7) and address counter (DB0 - DB6)

1

0

Data write operation (MPU writes data into DR)

1

1

Data read operation (MPU reads data from DR)

BUSY FLAG (BF)

BF = "High" indicates that the internal operation is being processed. So during this time the next instruction

cannot be accepted. BF can be read, when RS = Low and R/W = High (Read instruction Operation), through DB7

port.

Before executing the next instruction, be sure that BF is not High.

ADDRESS COUNTER (AC)

Address Counter (AC) stores the address of DDRAM/CGRAM that are transferred from IR. After writing into

(reading from) DDRAM/CGRAM data, AC is increased (decreased) by 1 automatically. When RS = "Low", and

R/W = "High", AC value can be read through DB0 - DB6 ports.

6

Share Link: