MX27L512PC-20 데이터 시트보기 (PDF) - Macronix International
부품명
상세내역
제조사
MX27L512PC-20 Datasheet PDF : 14 Pages
| |||
MX27L512
TWO-LINE OUTPUT CONTROL FUNCTION
To accommodate multiple memory connections, a two-
line control function is provided to allow for:
1. Low memory power dissipation,
2. Assurance that output bus contention will not
occur.
It is recommended that CE be decoded and used as the
primary device-selecting function, while OE be made a
common connection to all devices in the array and
connected to the READ line from the system control bus.
This assures that all deselected memory devices are in
their low-power standby mode and that the output pins
are only active when data is desired from a particular
memory device.
SYSTEM CONSIDERATIONS
During the switch between active and standby
conditions, transient current peaks are produced on the
rising and falling edges of Chip Enable. The magnitude
of these transient current peaks is dependent on the
output capacitance loading of the device. At a minimum,
a 0.1 uF ceramic capacitor (high frequency, low inherent
inductance) should be used on each device between
VCC and GND to minimize transient effects. In addition,
to overcome the voltage drop caused by the inductive
effects of the printed circuit board traces on EPROM
arrays, a 4.7 uF bulk electrolytic capacitor should be
used between VCC and GND for each eight devices.
The location of the capacitor should be close to where
the power supply is connected to the array.
MODE SELECT TABLE
MODE
Read
Output Disable
Standby (TTL)
Standby (CMOS)
Program
Program Verify
Program Inhibit
Manufacturer Code(3)
Device Code(3)
CE
VIL
VIL
VIH
VCC±0.3V
VIL
VIL
VIH
VIL
VIL
NOTES: 1. VH = 12.0 V ± 0.5 V
2. X = Either VIH or VIL
OE/VPP
VIL
VIH
X
X
VPP
VIL
VPP
VIL
VIL
PINS
A0
A9
X
X
X
X
X
X
X
X
X
X
X
X
X
X
VIL
VH
VIH
VH
OUTPUTS
DOUT
High Z
High Z
High Z
DIN
DOUT
High Z
C2H
91H
3. A1 - A8 = A10 - A15 = VIL(For auto select)
4. See DC Programming Characteristics for VPP voltage during
programming.
P/N:PM0256
REV. 2.6, AUG. 26, 2003
3
Share Link: 