AN87C196CA18 데이터 시트보기 (PDF) - Intel

부품명

상세내역

제조사

AN87C196CA18

Advanced 16-Bit CHMOS Microcontroller

Intel 

Automotive — 87C196CA 18 MHz Microcontroller

Table 2.

Pin Descriptions (Sheet 2 of 2)

Symbol

P5.6/READY

P5.4/SLPINT

P6.2/T1CLK

P6.3/T1DIR

PORT1/EPA0–3

P6.0–6.1/EPA8–9

PORT 0/ACH2–7

P6.4–6.7/SSIO

PORT 2

PORT 3 and 4

TXCAN

RXCAN

Name and Function

Ready input to lengthen external memory cycles, for interfacing with slow or

dynamic memory, or for bus sharing. If the pin is high, CPU operation continues in

a normal manner. If the pin is low prior to the falling edge of CLKOUT, the memory

controller goes into a wait state mode until the next positive transition in CLKOUT

occurs with READY high. When external memory is not used, READY has no

effect. The max number of wait states inserted into the bus cycle is controlled by

the CCR/CCR1. Also an LSIO pin when READY is not selected.

Dual functional I/O pin. As a bidirectional port pin (LSIO) or as a system function.

The system function is a Slave Port Interrupt Output Pin.

Dual function I/O pin. Primary function is that of a bidirectional I/O pin (LSIO);

however it may also be used as a TIMER1 Clock input. The TIMER1 will increment

or decrement on both positive and negative edges of this pin.

Dual function I/O pin. Primary function is that of a bidirectional I/O pin (LSIO);

however it may also be used as a TIMER1 Direction input. The TIMER1 will

increment when this pin is high and decrements when this pin is low.

Dual function I/O port pins. Primary function is that of bidirectional I/O (LSIO).

System function is that of High Speed capture and compare. EPA0 and EPA2

have yet another function of T2CLK and T2DIR of the TIMER2 timer/counter.

6-bit high impedance input-only port. These pins can be used as digital inputs

and/or as analog inputs to the on-chip A/D converter. These pins are also used as

inputs to EPROM parts to select the Programming Mode.

Dual function I/O ports that have a system function as Synchronous Serial I/O.

Two pins are clocks and two pins are data, providing full duplex capability.

6-bit multi-functional port. All of its pins are shared with other functions.

8-bit bidirectional I/O ports with open drain outputs. These pins are shared with the

multiplexed address/data bus which has strong internal pullups.

Push-pull output to the CAN bus line.

High-impedance input-only from the CAN bus line.

Datasheet

7

Share Link: