ADPF 데이터 시트보기 (PDF) - Gamewell-FCI by Honeywell

부품명

상세내역

제조사

ADPF

Analog Addressable Low-Flow Duct Sensor

Gamewell-FCI by Honeywell 

Velociti® Series

ADPF and ADPRF

Description

The Gamewell-FCI Velociti® Series, low-flow photoelec-

tronic air duct smoke sensors are capable of sensing

smoke in air velocities from 100 to 4,000 feet per minute

(0.5 to 20.32 m/sec.).

Analog Addressable

Low-Flow Duct Sensor

ADPF sensors feature low-flow technology that enables

duct smoke detection throughout a broad range of airflow

environments. Many difficult to solve HVAC applications

ADPF

occur in low airflow duct applications where reliable smoke

detection is critical. ADPF low-flow technology can detect

smoke at air speed velocities of 100 feet per minute or

greater, while continuing the same reliable performance to

4,000 feet per minute.

The ADPF sensor samples air currents passing through a

duct and gives dependable performance for shutdown of

fans, blowers, and air conditioning systems, preventing

the spread of toxic smoke and fire gases through the pro-

tected area.

The Velociti® Series use a communication protocol that

substantially increases the speed of communication

between the sensors and certain Gamewell-FCI analog

addressable fire alarm controls. These devices operate in

a grouped fashion. If one of the devices in the group has a

status change, the panel’s microprocessor stops the group

poll and concentrates on the single device. The net effect

is a response speed up to five times greater than earlier

designs.

These intelligent sensors communicate and are continu-

ously monitored through the signaling line circuit. Sensor

sensitivity changes caused by dirt, temperature, or humid-

ity are reported to the panel, allowing compensation algo-

rithms to maintain the sensor’s set sensitivity. An advance

indication at the panel specifies the sensor address, allow-

ing for selected maintenance to be performed as needed.

ADPRF

Features

• Air velocity rating from 100 to 4,000 feet per minute

(0.5 to 20.32 m/sec.)

• Patented telescopic sampling tube

• Easily accessible code switches

• Outside mounting tabs

• Easy and quick mounting to round or rectangular ducts

from 1'-12' (0.3-3.7 meters) wide

• Easy to clean

• UL recognized field-replaceable power and sensor

boards

• Transparent cover for convenient visual inspection.

Bi-color LEDs flash green whenever the sensor is

addressed, and light steady red on alarm

*Note: Only the red LED is operative in panels that do not operate

in Velociti mode.

An ISO 9000-2000 Company

SIGNALING

Velociti® and E3 Series® are registered trademarks of Honeywell International Inc.

S1913

FM MEA

APPROVED Approved

3023594 219-02-E Vol.VI 03240-0694:238

GAMEWELL-FCI

12 Clintonville Road, Northford, CT 06472-1610 USA • Tel: (203) 484-7161 • Fax: (203) 484-7118

Specifications are for information only, are not intended for installation purposes, and are subject to change without notice. No responsibility is assumed by Gamewell-FCI for their use.

©2008 by Honeywell International Inc. All rights reserved.

www.gamewell-fci.com

9020-0622 Rev. C page 1 of 2

Share Link: