SX1243 데이터 시트보기 (PDF) - Semtech Corporation

부품명

상세내역

제조사

SX1243

Low Cost Low Current Integrated Transmitter 310 to 928MHz Frequency Agile

Semtech Corporation 

WIRELESS & SENSING

SX1243

Integrated Transmitter IC

DATASHEET

4.3. Application Mode: Power & Go

The default ‘Power & Go’ application mode sees the SX1243 configured as detailed in Table 6. By changing the logical

state of the CTRL pin at Power-up or Reset, two distinct configuration modes can be selected. The Power & Go application

modes hence permit microcontroller-less operation.

Table 6 Configuration in Power & Go Mode

CTRL Pin

Configuration

‘Low’ FSK 868.3 MHz, +10 dBm, Fdev=+/-19.2 kHz

‘High’ OOK 433.92 MHz, +10 dBm

Mode

Power&Go 1

Power&Go 2

4.4. Application Mode: Advanced

4.4.1. Advanced Mode: Configuration

As described on Figure 4, Advanced mode is entered when accessing the Two Wire Interface (TWI) bus of the SX1243.

Upon communication to the register at up to 10 MHz of clocking speed, complete flexibility on the use of the chip is

obtained.

Once all register settings are selected (see registers detailed description in section [5]), the SX1243 can be used either in

Automatic mode by simply toggling the DATA pin, or in Forced Transmit mode to optimize timings for instance.

4.4.2. Frequency Hopping Spread Spectrum

Frequency hopping is supported in Advanced mode. After sending the data stream in the first channel, the user can send

a Frequency change instruction containing the new channel frequency. The circuit will automatically ramp down the PA,

lock the PLL to the new frequency, and turn the Power Amplifier back on. The user can then send his packet data on the

new channel. Timings are detailed hereafter:

t < TOFFT

(2 or 20 ms)

TWI

instruction

t < TOFFT

(2 or 20 ms)

DATA

Frequency change

CTRL

Frequency change

RFOUT

5th falling

edge on CTRL

24th falling

edge on CTRL

Tx Channel A

TS_HOPi

Figure 6. Frequency Hopping Description

Tx Channel B

Notes - During any TWI access, the input of the modulator is inhibited

- The time between two Frequency change instructions shall be greater than TS_HOPi

- FHSS modulation, as described under FCC part 15.247, is supported by the SX1243; also note that the large

Frequency Deviation settings available on the SX1243 make it suitable for “Digitally Modulated Systems”, as

described under FCC Part 15.247 (a)(2)

SX1243, Rev 3, May 2012

©2012 Semtech Corporation

Page 11

www.semtech.com

Share Link: