LC895198 데이터 시트보기 (PDF) - SANYO -> Panasonic
부품명
상세내역
제조사
LC895198 Datasheet PDF : 10 Pages
| |||
LC895198
Continued from preceding page.
Pin No.
Pin
Type
Function
101
ZCS3FX
I
102
ZDASP
B
ATAPI control signal
103
ZHRST
104
VDD1
105
VDD1
106
VDD0
107
VDD1
108
ZRESET
I
P
3.3 V
P
3.3 V
P
5.0 V
P
3.3 V
I
IC reset input
109
VDD1
110
VSS0
111
TEST1
112
VSS0
113
ATPINSEL
114
VSS0
115
TEST0
116
VDD0
117
AUDIOCK
118
VDD0
119
VDD0
120
VSS0
P
3.3 V
P
I
Test pin. This pin must be connected to VSS in normal operation.
P
I
ATAPI pin layout selection. This pin must be connected to VDD0.
P
I
Test pin. This pin must be connected to VSS in normal operation.
I
5.0 V
I
Clock input for the CAV audio block
P
5.0 V
P
5.0 V
P
• Unused ("NC") pins must be left open.
• Pins whose name begin with a Z operate with inverted (negative) logic.
• VSS0 is the logic system ground and VSS1 is the IDE interface driver ground.
• Applications must supply 5.0 V to VDD0 and 3.3 V to VDD1.
Specifications of any and all SANYO products described or contained herein stipulate the performance,
characteristics, and functions of the described products in the independent state, and are not guarantees
of the performance, characteristics, and functions of the described products as mounted in the customer’s
products or equipment. To verify symptoms and states that cannot be evaluated in an independent device,
the customer should always evaluate and test devices mounted in the customer’s products or equipment.
SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all
semiconductor products fail with some probability. It is possible that these probabilistic failures could
give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire,
or that could cause damage to other property. When designing equipment, adopt safety measures so
that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective
circuits and error prevention circuits for safe design, redundant design, and structural design.
In the event that any or all SANYO products (including technical data, services) described or contained
herein are controlled under any of applicable local export control laws and regulations, such products must
not be exported without obtaining the export license from the authorities concerned in accordance with the
above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system,
or otherwise, without the prior written permission of SANYO Electric Co., Ltd.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the “Delivery Specification”
for the SANYO product that you intend to use.
Information (including circuit diagrams and circuit parameters) herein is for example only; it is not
guaranteed for volume production. SANYO believes information herein is accurate and reliable, but
no guarantees are made or implied regarding its use or any infringements of intellectual property rights
or other rights of third parties.
This catalog provides information as of November, 1999. Specifications and information herein are
subject to change without notice.
PS No. 6237-10/10
Share Link: 