TB62709FG 데이터 시트보기 (PDF) - Toshiba
부품명
상세내역
제조사
TB62709FG Datasheet PDF : 29 Pages
| |||
PIN FUNCTIONS
TB62709NG/FG
PIN NUMBER PIN NAME
FUNCTION
1
VDD
5 V power pin.
2
DATA−IN (DI) Serial data input pin.
3
CLOCK (CK) Clock input pin. The shift register shifts data on the clock's rising edge.
Load signal input pin. The data in the D8 to D15 are read on the rising edge and the current
4
LOAD (LD)
load register the is selected from among the Duty Register, the Decode & Digit Register, or
Data Registers 0 to 3. The D0 to D7 bits of the 16−bit shift register contain data corresponding
to the same registers just described, which are read on the load signal's falling edge.
5~12
OUT−A to
OUT−Dp
Segment drive output pins. The A to Dp outputs correspond to the seven segments. These
pins output constant sink current. Connect each of these pins to the corresponding LED's
cathode.
13, 21
P−GND
Ground pins, There are two which can be used to ground the output OUT−A to OUT−Dp pins.
14
TEST−IN2 Product test pin. In normal use, be sure to connect to ground.
15
TEST−IN1 Product test pin. In normal use, be sure to connect to ground.
16, 17, 19, 20
DIG−0 to DIG−3
Digit output pins. Each of these pins can control one of the four seven−segment digits in a
display.
These pins output the VCC pin voltage as a source current output. Connect these pins to the
LED anodes.
18
VCC
Power pin for digit output.
22
R−EXT
Current setting pin for the OUT−A to OUT−Dp pins. Connect a resistor between this pin and
ground when setting the current.
23
DATA−OUT (DO)
Serial data output pin. Use when TB62709NG or TB62709FG devices are used in cascade
connections.
24
L−GND
Ground pin for logic and analog circuits.
3
2006-06-14
Share Link: 