TDA6502 데이터 시트보기 (PDF) - Philips Electronics

부품명

상세내역

제조사

TDA6502

5 V mixers/oscillators and synthesizers for cable TV and VCR 2-band tuners

Philips Electronics 

Philips Semiconductors

5 V mixers/oscillators and synthesizers for

cable TV and VCR 2-band tuners

Product specification

TDA6502; TDA6502A;

TDA6503; TDA6503A

Depending on the voltage applied to pin SW (see Table 2)

the device is operating in the I2C-bus mode or 3-wire bus

mode.

In the 3-wire bus mode, pin LOCK/ADC is the ‘lock’ output

of the PLL and is at LOW level when the PLL is locked.

Lock detector bit FL of the status byte is set to logic 1 when

the loop is locked and is read on the SDA line during a

READ operation in I2C-bus mode only.

In the I2C-bus mode only, pin LOCK/ADC is the ADC input

for digital AFC control. The ADC code is read during a

READ operation on the I2C-bus.

In the test mode, in both I2C-bus mode and 3-wire bus

mode, pin LOCK/ADC is used as a test output for fREF and

1⁄2fDIV.

3.1 I2C-bus format

Five serial bytes (including the address byte) are required

to address the device, select the VCO frequency, program

the four ports, set the charge pump current and set the

reference divider ratio. The device has four independent

I2C-bus addresses which can be selected by applying a

specific voltage to pin CE/AS.

3.2 3-wire bus format

Data is transmitted to the device during a HIGH level on

pin CE/AS (enable line). The device is accessible with

18-bit and 19-bit data formats (see Figs 4 and 5). The first

four bits are used to program the PMOS ports and the

remaining bits control the programmable divider. A 27-bit

data format (see Fig.6) may also be used to set the charge

pump current, the reference divider ratio and the test

modes.

It is not allowed to address the device with words whose

length is different from 18, 19 or 27 bits.

Table 1 Data word length for 3-wire bus format

DATA WORD

18-bit

19-bit

27-bit

REFERENCE

DIVIDER(1)

64

1 28

programmable

FREQUENCY

STEP

62.50 kHz

31.25 kHz

programmable

Note

1. The selection of the reference divider is given by an

automatic identification of the data word length. When

the 27-bit format is used, the reference divider is

controlled by bits RSA and RSB (see Table 8). More

details are given in Section 8.3.

2001 Aug 22

4

Share Link: