TDA7492
4
Characterization curves
Characterization curves
The general test conditions used for producing the characterization curves can be
summarized as follows:
Test board: SZ LAB TDA7492 slug-up demo board
Test frequency: 1 kHz (also 100 Hz for THD vs. output power only)
Output power: 1 W
For 6-loads
– test voltage: 25 V
– LC filter: L = 22 μH and C = 220 nF
For 8-loads
– test voltage: 25 V
– LC filter: L = 33 μH and C = 220 nF
For 4-loads
– test voltage: 20 V
– LC filter: L = 15 μH and C = 470 nF.
Figure 28 on page 22 shows the circuit with which the characterization curves, shown in the
next sections, were measured. Figure 27 on page 21 shows the PCB layout.
4.1
Characterizations for 6- loads
Figure 3. Output power vs. supply voltage
Test conditions:
Vcc = 15 - 25 V,
RL = 6 Ω,
Rosc = 39 kΩ, Cosc = 100 nF,
f = 1 kHz,
Gv = 30 dB,
Tamb = 25r C
Specification limit:
Typical:
Vs = 25 V, RL = 6 Ω,
Po = 50 W atTHD = 10%,
Po = 40 W atTHD = 1%
3RXWYV9FF
10% THD
1% THD
9FF9
DocID014926 Rev 6
11/32
32