S393C 데이터 시트보기 (PDF) - STMicroelectronics
부품명
상세내역
제조사
S393C Datasheet PDF : 12 Pages
| |||
Absolute maximum ratings
1
Absolute maximum ratings
TS393
Table 1. Absolute maximum ratings (AMR)
Symbol
Parameter
Value
Unit
VCC+
Supply voltage (1)
18
Vid
Differential input voltage (2)
±18
Vin
Input voltage (3)
18
Vo
Output voltage
18
Io
Output current
20
IF
Forward current in ESD protection diodes on inputs(4)
50
Tj
Maximum junction temperature
150
Thermal resistance junction to ambient (5)
Rthja
DIP8
SO-8
85
125
TSSOP8
120
Thermal resistance junction to case (5)
Rthjc
DIP8
SO-8
41
40
TSSOP8
37
V
V
V
V
mA
mA
°C
°C/W
°C/W
Tstg
ESD
Storage temperature range
HBM: human body model(6)
MM: machine model(7)
CDM: charged device model (8)
-65 to +150
°C
500
V
200
V
1
kV
1. All voltage values, except differential voltage, are with respect to network ground terminal.
2. Differential voltages are the non-inverting input terminal with respect to the inverting input terminal.
3. Excursions of input voltages may exceed the power supply level. As long as the common mode voltage
[Vicm=(Vin+ + Vin-)/2] remains within the specified range, the comparator will provide a stable output state.
However, the maximum current through the ESD diodes (IF) of the input stage must strictly be observed.
4. Guaranteed by design.
5. Short-circuits can cause excessive heating and destructive dissipation. Values are typical.
6. Human body model: A 100 pF capacitor is charged to the specified voltage, then discharged through a
1.5 kΩ resistor between two pins of the device. This is done for all couples of connected pin combinations
while the other pins are floating.
7. Machine model: A 200 pF capacitor is charged to the specified voltage, then discharged directly between
two pins of the device with no external series resistor (internal resistor < 5 Ω). This is done for all couples of
connected pin combinations while the other pins are floating.
8. Charged device model: all pins and the package are charged together to the specified voltage and then
discharged directly to the ground through only one pin. This is done for all pins.
2/12
Share Link: 