WM9713 데이터 시트보기 (PDF) - Wolfson Microelectronics plc
부품명
상세내역
제조사
WM9713 Datasheet PDF : 108 Pages
| |||
Pre-Production
WM9713L
DIGITAL INTERFACE CHARACTERISTICS
Test Conditions
DBVDD = 3.3V, DCVDD = 3.3V, TA = +25oC, unless otherwise stated.
PARAMETER
SYMBOL TEST CONDITIONS
Digital Logic Levels (all digital input or output pins) – CMOS Levels
Input HIGH level
VIH
Input LOW level
VIL
Output HIGH level
VOH
source current = 2mA
Output LOW level
VOL
sink current = 2mA
Clock Frequency
Master clock (MCLKA pin)
AC’97 bit clock (BIT_CLK pin)
AC’97 sync pulse (SYNC pin)
MIN
DBVDD×0.7
DBVDD×0.9
TYP
24.576
12.288
48
MAX
DBVDD×0.3
DBVDD×0.1
Note:
1. All audio and non-audio sample rates and other timing scales proportionately with the master clock.
2. For signal timing on the AC-Link, please refer to the AC’97 specification (Revision 2.2)
UNIT
V
V
MHz
MHz
kHz
POWER CONSUMPTION
The power consumption of the WM9713L depends on the following factors:
• Supply voltages: Reducing the supply voltages also reduces digital supply currents, end therefore results in
significant power savings especially in the digital sections of the WM9713L.
• Operating mode: Significant power savings can be achieved by always disabling parts of the WM9713L that are
not used (e.g. audio ADC, DAC, touchpanel digitiser).
• Sample rates: Running at lower sample rates will reduce power consumption significantly. The figures below are
for 48kHz (unless otherwise specified), but in many scenarios it is not necessary to run at this frequency, e.g.
8kHz PCM voice call scenario uses only 11.4mW (see below).
MODE DESCRIPTION
Off (lowest possible power)
Clocks stopped. This is the default configuration after power-up.
LPS (Low Power Standby)
VREF maintained using 1MOhm string
Touchpanel only (waiting for pen-down)
PCM Voice call (fs=8kHz)
Record from mono microphone
Stereo DAC Playback (AC link to headphone)
Stereo DAC Playback (AC link to headphone)
PLL running with 13MHz input to MCLKB
Maximum Power - everything on
Table 1 Supply Current Consumption
AVDD
Supply
Current
V / mA
3.3 0.01
DCVDD
Supply
Current
V / mA
3.3 0
DBVDD
Supply
Current
Total
Power
(mW)
V / mA
3.3 0.005 0.05
3.3 0.014 3.3 0 3.3 0.005 0.06
3.3 0.042 3.3 0 3.3 0.005 0.15
2.8 2.37 2.8 1.7 2.8 0.006 11.4
3.3 3.644 3.3 10.973 3.3 2.974 58.05
3.3 3.733 3.3 9.720 3.3 2.789 53.60
3.3 4.801 3.3 10.504 3.3 2.814 59.79
3.3 13.656 3.3 15.472 3.3 2.938 105.82
Notes:
1. Unless otherwise specified, all figures are at TA = +25C, audio sample rate fs = 48kHz, with zero signal (quiescent), and
voltage references settled.
2. The power dissipated in the headphone, speaker and touchpanel is not included in the above table.
w
PP Rev 3.0 June 2006
11
Share Link: 