MFC1000 데이터 시트보기 (PDF) - Conexant Systems

부품명

상세내역

제조사

MFC1000

MFC1000 Controller and a Conexant MONOFAX Modem device

Conexant Systems 

Synchronous Receiver Transmitter (SOPIF)

One synchronous only serial interface (SOPIF) is

built into the MFC1000, allowing the MFC1000 to

communicate with the external operator panel

module and with other external peripherals. The

SOPIF provides separate signals for Data (SSTXD,

SSRXD), Clock (SSCLK), and optional Data

Request / Data Acknowledge (SSREQ/SSACK). It is

a full duplex, three-wire system. The SOPIF may be

configured to operate as either a master or slave

interface. The bit rate, clock polarity, clock phase,

and data shifting order are programmable.

Synchronous/Asynchronous Receiver Transmitter

(SASIF)

One Synchronous/Asynchronous serial interface

(SASIF) which performs serial-parallel conversion on

data received from a peripheral device and parallel-

to-serial conversion of data for transmission to a

peripheral device. The interface consists of serial

transmit data (SASTXD), serial receive data

(SASRXD), and a serial clock (SASSCLK) signals.

The SASIF includes a programmable bit rate

generator for asynchronous and synchronous

operations. The data shifting order, Data bit number,

and the SASSCLK polarity are programmable.

Real-Time Clock (RTC)

The MFC1000 includes a battery backup real-time

clock. The RTC automatically maintains the correct

date and time for 32 years. The leap year

compensation is included. A 32.768 kHz or 65.536

kHz watch crystal is required by the RTC.

Tone/Bell/Ring Generator

The MFC1000 provides three programmable clock

generator outputs. Two of the generators are used

as tone generators and the third as a bell or ring

driver.

 

General Purpose Inputs and/or Outputs

The MFC1000 provides up to 15 GPIO’s and 8

GPO's.

1284 Bi-directional Parallel Interface

An IEEE 1284 compatible bi-directional peripheral

parallel port is provided. Compatibility, nibble, byte,

and ECP modes are supported. The Parallel I/O

interface can be programmed to support CPU or

DMA data transfers. DMA is available in

Compatibility, nibble, and ECP modes.

Autobaud

An autobaud circuit supports detection of baud rate

and data structure (parity and character length) for

programming an external UART. A precision timer,

shift register and edge detector are included to

determine the width of the start bit and to sample the

serial data stream. Serial data rates up to 115.2

KBPS are supported.

Watchdog Timer

The Watchdog Timer guards against firmware

lockup on the part of either Executive-controlled

background tasks or interrupt-driven tasks, and can

be only enabled by a sequence of events under

control of the Watchdog Control Logic. Once the

Watchdog Timer has been enabled, it can not be

disabled unless a system reset occurs.

Reset and Power Control

The BATRSTn input initializes the MFC1000 at

power-on. An externally generated power-down

input, PWRDWNn, controls switching between

primary and battery power. The open drain RESETn

I/O pin provides a reset output to external circuits, or

can accept an externally generated reset. The

external reset will not reset the RTC. Separate

DRAM and RTC battery power inputs are provided

for battery-backed up functions.

MD192

7

Share Link: