DS1836 데이터 시트보기 (PDF) - Maxim Integrated

부품명

상세내역

제조사

DS1836

3.3V/5V Micro Manager

Maxim Integrated 

OUTPUT VALID CONDITIONS

DS1836A/B/C/D

The DS1836 can maintain valid outputs as long as one input remains above 1.2V. However, the RST

outputs on the DS1836A (or C) use a push-pull output structure which can maintain a valid output below

1.2V on an input. To sink current below 1.2V a resistor can be connected from RST to GND (see Figure

5). This arrangement will maintain a valid value on the RST outputs even if all supply inputs are at 0V.

During conditions when the RST is in the inactive or high state this arrangement will draw current

through the pull down resistor. A value of about 100 kΩ should be adequate to maintain a valid condition.

The DS1836 NMI output requires a pull-up resistor on the output to maintain a valid output. The value of

the resistor is not critical in most cases but must be set low enough to pull the output to a high state. A

common value used is 10kΩs (see Figure 3).

APPLICATION DIAGRAM:

RST VALID TO 0V VCC ON THE DS1836A OR DS1836C Figure 5

TIMING DIAGRAM: POWER-UP Figure 6

5 of 9

Share Link: