10JL2C48A 데이터 시트보기 (PDF) - Toshiba
부품명
상세내역
제조사
10JL2C48A Datasheet PDF : 4 Pages
| |||
ELECTRICAL CHARACTERISTICS (Ta = 25°C)
10JL2C48A,U10JL2C48A
CHARACTERISTIC
Peak Forward Voltage
Repetitive Peak Reverse
Current
Reverse Recovery Time
Junction Capacitance
Thermal Resistance
Note: A value of one cell.
SYMBOL
TEST CONDITION
(Note) VFM
IFM = 5A
(Note)
(Note)
IRRM
trr
Cj
Rth (j−c)
VRRM = 600V
IF = 2A, di / dt = −20A / μs
VR = 10V, f = 1.0MHz
DC Total
MIN. TYP. MAX. UNIT
⎯
⎯
4.0
V
⎯
⎯
50 μA
⎯
⎯
35 ns
⎯
36
⎯ pF
⎯
⎯
2.5 °C / W
MARKING
10JL2C
Characteristics
indicator
Part No. (or abbreviation code)
Lot No.
A line indicates
lead (Pb)-free package or
lead (Pb)-free finish.
Abbreviation Code
10JL2C
10JL2C
Part No.
10JL2C48A
U10JL2C48A
Handling Precaution
The absolute maximum ratings denote the absolute maximum ratings, which are rated values and must not be
exceeded during operation, even for an instant. The following are the general derating methods that we recommend
when you design a circuit with a device.
VRRM:
We recommend that the worst case voltage, including surge voltage, be no greater than 80% of the
absolute maximum rating of VRRM for a DC circuit and be no greater than 50% of that of VRRM for
an AC circuit. VRRM has a temperature coefficient of 0.1%/°C. Take this temperature coefficient into
account designing a device at low temperature.
IO:
We recommend that the worst case current be no greater than 80% of the absolute maximum rating
of IO. Carry out adequate heat design. If you can’t design a circuit with excellent heat radiation, set
the margin by using an allowable Tamax-IO curve.
This rating specifies the non-repetitive peak current in one cycle of a 50-Hz sine wave, condition angle 180.
Therefore, this is only applied for an abnormal operation, which seldom occurs during the lifespan of the device.
We recommend that a device be used at a Tj of below 120°C under the worst load and heat radiation conditions.
Please refer to the Rectifiers databook for further information.
2
2006-11-08
Share Link: 