ADUC812(1999) 데이터 시트보기 (PDF) - Analog Devices

부품명

상세내역

제조사

ADUC812
(Rev.:1999)

MicroConverter™, Multichannel 12-Bit ADC with Embedded FLASH MCU

Analog Devices 

ADuC812

Mnemonic

ALE

EA

P0.7–P0.0

(A0–A7)

Type Function

O Address Latch Enable, Logic Output. This output is used to latch the low byte (and middle byte for 24-bit

address space accesses) of the address into external memory during normal operation. It is activated every

six oscillator periods except during an external data memory access.

I

External Access Enable, Logic Input. When held high, this input enables the device to fetch code from

internal program memory locations 0000H to 1FFFH. When held low this input enables the device to fetch

all instructions from external program memory.

I/O Port 0 is an 8-bit open drain bidirectional I/O port. Port 0 pins that have 1s written to them float and in that

state can be used as high impedance inputs. Port 0 is also the multiplexed low order address and data bus

during accesses to external program or data memory. In this application it uses strong internal pull-ups

when emitting 1s.

TERMINOLOGY

ADC SPECIFICATIONS

Integral Nonlinearity

This is the maximum deviation of any code from a straight line

passing through the endpoints of the ADC transfer function.

The endpoints of the transfer function are zero scale, a point

1/2 LSB below the first code transition and full scale, a point

1/2 LSB above the last code transition.

Differential Nonlinearity

This is the difference between the measured and the ideal 1 LSB

change between any two adjacent codes in the ADC.

Offset Error

This is the deviation of the first code transition (0000 . . . 000)

to (0000 . . . 001) from the ideal, i.e., +1/2 LSB.

Full-Scale Error

This is the deviation of the last code transition from the ideal

AIN voltage (Full Scale – 1.5 LSB) after the offset error has

been adjusted out.

Signal to (Noise + Distortion) Ratio

This is the measured ratio of signal to (noise + distortion) at the

output of the A/D converter. The signal is the rms amplitude of

the fundamental. Noise is the rms sum of all nonfundamental

signals up to half the sampling frequency (fS/2), excluding dc.

The ratio is dependent upon the number of quantization levels

in the digitization process; the more levels, the smaller the quan-

tization noise. The theoretical signal to (noise +distortion) ratio

for an ideal N-bit converter with a sine wave input is given by:

Signal to (Noise + Distortion) = (6.02N + 1.76) dB

Thus for a 12-bit converter, this is 74 dB.

Total Harmonic Distortion

Total Harmonic Distortion is the ratio of the rms sum of the

harmonics to the fundamental.

DAC SPECIFICATIONS

Relative Accuracy

Relative accuracy or endpoint linearity is a measure of the maxi-

mum deviation from a straight line passing through the end-

points of the DAC transfer function. It is measured after

adjusting for zero error and full-scale error.

Voltage Output Settling Time

This is the amount of time it takes for the output to settle to a

specified level for a full-scale input change.

Digital to Analog Glitch Impulse

This is the amount of charge injected into the analog output

when the inputs change state. It is specified as the area of the

glitch in nV sec.

REV. 0

–7–

Share Link: