LC7073 데이터 시트보기 (PDF) - SANYO -> Panasonic
부품명
상세내역
제조사
LC7073 Datasheet PDF : 9 Pages
| |||
LC7073, 7073M
Sync Detection Method
The LC7070N/LC7070NM/LC7071NM searches for 5 consecutive blocks in the correct sequence within each group of
12 blocks. The LC7073/LC7073M searches for 2 consecutive blocks in the correct sequence within each group of 3
blocks.
Data Output After Sync Detection
The LC7070N/LC7070NM/LC7071NM starts data output with the first block (offset A) directly after the last block in the
sync detection group. If sync detection occurs during the first block (offset A), the LC7073/LC7073M starts data output
with the second block (offset B). If sync detection occurs during the second or third block (offset B or C), and finishes
before the end of the fourth block (offset D), the LC7073/LC7073M starts data output with the first block (offset A) of the
second group.
Sync Error
A sync error occurs if no offset word is detected for more than five consecutive blocks. This applies to both the LC7070N/
LC7070NM/LC7071NM and LC7073/LC7073M.
Error Correction
In error-correction mode, an error of less than 5 bits is corrected to an accuracy of 5 bits. This applies to both the
LC7070N/LC7070NM/LC7071NM and the LC7073/LC7073M.
Precaution
Note that the solder-dip method should not be used for the LC7073M (MFP).
Specifications of any and all SANYO products described or contained herein stipulate the performance,
characteristics, and functions of the described products in the independent state, and are not guarantees
of the performance, characteristics, and functions of the described products as mounted in the customer's
products or equipment. To verify symptoms and states that cannot be evaluated in an independent device,
the customer should always evaluate and test devices mounted in the customer's products or equipment.
SANYO Electric Co., Ltd. strives to supply high-quality high-reliability products. However, any and all
semiconductor products fail with some probability. It is possible that these probabilistic failures could
give rise to accidents or events that could endanger human lives, that could give rise to smoke or fire,
or that could cause damage to other property. When designing equipment, adopt safety measures so
that these kinds of accidents or events cannot occur. Such measures include but are not limited to protective
circuits and error prevention circuits for safe design, redundant design, and structural design.
In the event that any or all SANYO products(including technical data,services) described or
contained herein are controlled under any of applicable local export control laws and regulations,
such products must not be exported without obtaining the export license from the authorities
concerned in accordance with the above law.
No part of this publication may be reproduced or transmitted in any form or by any means, electronic or
mechanical, including photocopying and recording, or any information storage or retrieval system,
or otherwise, without the prior written permission of SANYO Electric Co., Ltd.
Any and all information described or contained herein are subject to change without notice due to
product/technology improvement, etc. When designing equipment, refer to the "Delivery Specification"
for the SANYO product that you intend to use.
Information (including circuit diagrams and circuit parameters) herein is for example only ; it is not
guaranteed for volume production. SANYO believes information herein is accurate and reliable, but
no guarantees are made or implied regarding its use or any infringements of intellectual property rights
or other rights of third parties.
This catalog provides information as of July, 2001. Specifications and information herein are subject to
change without notice.
PS No.3932–9/9
Share Link: 