AT45DB041E 데이터 시트보기 (PDF) - Unspecified
부품명
상세내역
제조사
AT45DB041E Datasheet PDF : 71 Pages
| |||
Description
The AT45DB041E is a 1.65V minimum, serial-interface sequential access Flash memory ideally suited for a wide variety
of digital voice, image, program code, and data storage applications. The AT45DB041E also supports the RapidS serial
interface for applications requiring very high speed operation. Its 4,194,304 bits of memory are organized as 2,048 pages
of 256 bytes or 264 bytes each. In addition to the main memory, the AT45DB041E also contains two SRAM buffers of
256/264 bytes each. The buffers allow receiving of data while a page in the main memory is being reprogrammed.
Interleaving between both buffers can dramatically increase a system's ability to write a continuous data stream. In
addition, the SRAM buffers can be used as additional system scratch pad memory, and E2PROM emulation (bit or byte
alterability) can be easily handled with a self-contained three step read-modify-write operation.
Unlike conventional Flash memories that are accessed randomly with multiple address lines and a parallel interface, the
DataFlash® uses a serial interface to sequentially access its data. The simple sequential access dramatically reduces
active pin count, facilitates simplified hardware layout, increases system reliability, minimizes switching noise, and
reduces package size. The device is optimized for use in many commercial and industrial applications where
high-density, low-pin count, low-voltage, and low-power are essential.
To allow for simple in-system re-programmability, the AT45DB041E does not require high input voltages for
programming. The device operates from a single 1.65V to 3.6V power supply for the erase and program and read
operations. The AT45DB041E is enabled through the Chip Select pin (CS) and accessed via a 3-wire interface consisting
of the Serial Input (SI), Serial Output (SO), and the Serial Clock (SCK).
All programming and erase cycles are self-timed.
1. Pin Configurations and Pinouts
Figure 1-1. Pinouts
8-lead SOIC
Top View
SI 1
SCK 2
RESET 3
CS 4
8 SO
7 GND
6
VCC
5 WP
8-pad UDFN
Top View
SI 1
SCK 2
RESET 3
CS 4
8 SO
7 GND
6 VCC
5 WP
8-ball UBGA
Top View
SCK GND VCC
CS NC WP
SO
SI RST
Note: 1. The metal pad on the bottom of the UDFN package is not internally connected to a voltage potential.
This pad can be a “no connect” or connected to GND.
AT45DB041E
2
8783F–DFLASH–10/2013
Share Link: 