FP1189-PCB1900S 데이터 시트보기 (PDF) - WJ Communications => Triquint

부품명

상세내역

제조사

FP1189-PCB1900S

½ - Watt HFET

WJ Communications => Triquint 

FP1189

½ - Watt HFET

Product Information

FP1189 (SOT-89 Package) Mechanical Information

This package may contain lead-bearing materials. The plating material on the leads is SnPb.

Outline Drawing

Product Marking

The FP1189 will be marked with an

“FP1189” designator. An alphanumeric lot

code (“XXXX-X”) is also marked below the

part designator on the top surface of the

package.

Tape and reel specifications for this part are

located on the website in the “Application

Notes” section.

MSL / ESD Rating

Land Pattern

ESD Rating: Class 1B

Value:

Passes /500V to <1000V

Test:

Human Body Model (HBM)

Standard: JEDEC Standard JESD22-A114

ESD Rating: Class IV

Value:

Passes at 2000 V min.

Test:

Charged Device Model (CDM)

Standard: JEDEC Standard JESD22-C101

MSL Rating: Level 3 at +235° C convection reflow

Standard: JEDEC Standard J-STD-020

Mounting Config. Notes

Thermal Specifications

Parameter

Rating

Operating Case Temperature

Thermal Resistance, Rth (1)

Junction Temperature, Tjc (2)

-40 to +85°C

68° C/W

153° C

1. The thermal resistance is referenced from the hottest

part of the junction to the ground tab (pin 4).

2. This corresponds to the typical drain biasing condition

of +8V, 125 mA at an 85°C case temperature. A

minimum MTTF of 1 million hours is achieved for

junction temperatures below 160 °C.

MTTF vs. GND Tab Temperature

100

1. Ground / thermal vias are critical for the proper

performance of this device. Vias should use a .35mm

(#80 / .0135”) diameter drill and have a final plated

thru diameter of .25 mm (.010”).

2. Add as much copper as possible to inner and outer

layers near the part to ensure optimal thermal

performance.

3. Mounting screws can be added near the part to fasten

the board to a heatsink. Ensure that the ground /

thermal via region contacts the heatsink.

4. Do not put solder mask on the backside of the PC board

in the region where the board contacts the heatsink.

5. RF trace width depends upon the PC board material

and construction.

6. Use 1 oz. Copper mi nimum.

7. All dimensions are in millimeters (inches). Angles are

in degrees.

10

1

0

60 70 80 90 100 110 120

Tab Temperature (°C)

Specifications and information are subject to change without notice.

WJ Communications, Inc • Phone 1-800- WJ1-4401 • FAX: 408-577-6621 • e- mail: sales@wj.com • Web site: www.wj.com

September 2004

Share Link: