Q102-N00XX 데이터 시트보기 (PDF) - Avago Technologies
부품명
상세내역
제조사
Q102-N00XX Datasheet PDF : 7 Pages
| |||
Absolute Maximum Ratings at TA = 25°C
Parameters
Title
DC Forward Current [1]
50 mA
Peak Forward Current [2]
300 mA
Average Forward Current [2,3]
30 mA
Transient Forward Current (10 s Pulse) [4]
500 mA
Power Dissipation
100 mW
Reverse Voltage
5V
Junction Temperature
110°C
Operating Temperature
-55°C to +100°C
Storage Temperature
-55°C to +100°C
Lead Soldering Temperature
[1.6 mm (0.063 in.) from body]
260°C for 5 seconds
Reflow Soldering Temperature
260°C for 20 seconds
Notes:
1. Derate linearly as shown in Figure 6.
2. Refer to Figure 7 to establish pulsed operating conditions.
3. Maximum IAVG at f = 1 kHz, DF = 10%.
4. The transient peak current is the maximum non-recurring peak current the device can withstand
without damaging the LED die and wire bonds. It is not recommended that the device be
operated at peak currents above the Absolute Maximum Peak Forward Current.
Optical Characteristics at TA = 25°C
Part Number
HLMP-
Luminous Intensity
IV (mcd)
@ 20 mA[1]
Min.
Typ.
Q106-R00xx
100
400
Q102-N00xx
25
100
P106-Q00xx
63
130
Total Flux
V (mlm)
@ 20 mA[2]
Typ.
280
-
280
Peak
Wavelength
peak (nm)
Typ.
654
654
654
Color, Dominant
Wavelength
d[3] (nm)
Typ.
644
644
644
Viewing Angle
2½
Degrees[4]
Typ.
15
35
75
Luminous
Efficacy
v[5]
(lm/w)
85
85
85
Optical Characteristics at TA = 25°C
Part Number
(Low Current)
HLMP-
Luminous Intensity
IV (mcd)
@ 0.5 mA[1]
Min.
Typ.
Total Flux
V (mlm)
@ 0.5 mA[2]
Typ.
Peak
Wavelength
peak (nm)
Typ.
Color, Dominant
Wavelength
d[3] (nm)
Typ.
Viewing Angle
2½
Degrees[4]
Typ.
Luminous
Efficacy
v[5]
(lm/w)
Q156-H00xx
2.5
7
10.5
654
644
15
85
Q152-G00xx
1.6
2
-
654
644
35
85
P156-EG0xx
0.63
2
10.5
654
644
75
85
Notes:
1. The luminous intensity, Iv, is measured at the mechanical axis of the lamp package. The actual peak of the spatial radiation pattern may not be
aligned with this axis.
2. v is the total luminous flux output as measured with an integrating sphere.
3. The dominant wavelength, d, is derived from the CIE Chromaticity Diagram and represents the color of the device.
4. 1/2 is the off-axis angle where the liminous intensity is 1/2 the peak intensity.
5. Radiant intensity, Iv, in watts/steradian, may be calculated from the equation Iv = Iv/v, where Iv is the luminous intensity in candelas and v is the
luminous efficacy in lumens/watt.
4
Share Link: 