LM2575 데이터 시트보기 (PDF) - HTC Korea

부품명

상세내역

제조사

LM2575

1A, 52kHz, Step-Down Switching Regulator

HTC Korea 

1A, 52kHz, Step-Down Switching Regulator

LM2575

PIN FUNCTION DESCRIPTION

Symbol

Description

1

Vin

This pin is the positive input supply for the LM2575 step–down switching

regulator.In order to minimize voltage transients and to supply the switching

currents needed by the regulator, a suitable input bypass capacitor must be

present .(Cin in Figure 1).

2 Output This is the emitter of the internal switch. The saturation voltage Vsat of this

output switch is typically 1.5 V. It should be kept in mind that the PCB area

connected to this pin should be kept to a minimum in order to minimize

coupling to sensitive circuitry.

3

Gnd Circuit ground pin. See the information about the printed circuit board layout.

4 Feedback This pin senses regulated output voltage to complete the feedback loop.

The signal is divided by the internal resistor divider network R2, R1 and

applied to the non–inverting input of the internal error amplifier. In the

Adjustable version of the LM2575 switching regulator this pin is the direct

input of the error amplifier and the resistor network R2, R1 is connected

externally to allow programming of the output voltage.

5 ON/OFF It allows the switching regulator circuit to be shut down using logic level

signals, thus dropping the total input supply current to approximately 80 mA.

The threshold voltage is typically 1.4 V. Applying a voltage above this value

(up to +Vin) shuts the regulator off. If the voltage applied to this pin is lower

than 1.4V or if this pin is left open, the regulator will be in the "on" condition

−8−

HTC

Share Link: