MAX9512ATE 데이터 시트보기 (PDF) - Maxim Integrated

부품명

상세내역

제조사

MAX9512ATE

Video Filter Amplifier with SmartSleep and Y/C Mixer Circuit

Maxim Integrated 

Video Filter Amplifier with SmartSleep

and Y/C Mixer Circuit

Active-Detect Mode

The active video detect circuit slices the YIN signal at

4.7% of the power supply (155mV for a 3.3V supply). If

the transitions occur at a rate of 14.3kHz or higher,

then a video signal is present. When the MAX9512

detects a video signal with sync at the YIN input, the

control logic enters the active-detect mode and

enables the load sense circuitry (Figure 3). The supply

current is typically 17µA.

If an output load is not connected to any amplifier, the

MAX9512 remains in active-detect mode. Eight times per

second, each load-sense circuit checks for a load by

connecting an internal 15kΩ pullup resistor to the output

for 1ms. If the output is pulled up, then no load is pre-

sent. If the output stays low, a load is connected.

Full-Operation Mode

If a load is connected to an output, the corresponding

filter and amplifier turn on and remain on until the out-

put load is disconnected. In full-operation mode,

SmartSleep intelligently reduces the supply current

based on the input signal presence and output loading.

Figures 4 and 5 show which portions of the MAX9512

turn on and which remain off with different load configu-

rations. In Figure 4, both filters and the Y/C mixer turn

on to generate the composite video signal for the ampli-

fier connected to CVBSOUT1. In Figure 5, only the luma

filter turns on, and the Y/C mixer stays off.

When an amplifier is on, it continually checks if the load

has been disconnected by detecting if the amplifier

output is sourcing current during a horizontal line time.

If no sourcing current is detected within one horizontal

line time (approximately 64µs), the load has been dis-

connected and the amplifier returns to active-detect

mode. If, at any time, the input video signal is removed,

the MAX9512 returns to standby mode.

If the SmartSleep feature is not activated and the part is

not in shutdown, then the filters and amplifiers com-

pletely turn on, regardless of whether there is a video

signal at the CVBSIN input and whether there are loads

connected at the outputs.

0

TO

50mV

VIDEO ENCODER

CURRENT

DAC

CURRENT

DAC

VIDEO SIGNAL

PRESENT

CIN

BUFFER

OFF

BUFFER

YIN

OFF

+3.3V

17μA

VDD

LPF

OFF

OFF

LPF

OFF

+3.3V

SMARTSLEEP

SHDN

ACTIVE VIDEO

DETECT

CONTROL

LOGIC

MAX9512

GND

LOAD SENSE

COUT

75Ω

6dB

OFF

LOAD SENSE

6dB

OFF

LOAD SENSE

6dB

OFF

LOAD SENSE

6dB

OFF

YOUT

75Ω

CVBSOUT1 75Ω

CVBSOUT2 75Ω

CHROMA

LUMA

NO

LOADS

CVBS1

CVBS2

Figure 3. Active-Detect Mode with No Output Loads

______________________________________________________________________________________ 11

Share Link: