DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

PSRDA3.3-4 데이터 시트보기 (PDF) - Protek Devices

부품명
상세내역
제조사
PSRDA3.3-4
PROTEC
Protek Devices PROTEC
PSRDA3.3-4 Datasheet PDF : 5 Pages
1 2 3 4 5
APPLICATION NOTE
PSRDA3.3-4
thru
PSRDA15-4
The PSRDAxx-4 Series are low capacitance, unidirectional TVS arrays that are designed to protect I/O or high speed data lines from the damaging
effects of ESD or EFT. This product series has a surge capability of 500 Watts PPP per line for an 8/20µs waveshape and offers ESD protection >
40kV.
DIFFERENTIAL-MODE CONFIGURATION (Figure 1)
Ideal for use in USB applications, the PSRDAxx-4 Series provides up
to four (4) lines of protection in a differential-mode configuration as
depicted in Figure 1.
Circuit connectivity is as follows:
Pins 1, 4, 6 and 7 are connected to the data lines.
Pins 5 and 8 are connected to ground.
Pins 2 and 3 are connected to the databus.
DIFFERENTIAL-MODE CONFIGURATION (Figure 2)
Figure 1. Typical Differential-Mode USB Protection
USB PORT
D+
VBUS
VBUS
D-
GND
4
3
2
1
The PSRDAxx-4 Series also provides up to four (4) lines of protection
in a differential-mode configuration as depicted in Figure 2 for T1/E1
applications.
Circuit connectivity is as follows:
Pins 1, 4, 6 and 7 are connected to the data lines.
Pins 5 and 8 are connected to ground.
Pins 2 and 3 are connected to the databus.
CIRCUIT BOARD LAYOUT RECOMMENDATIONS
Circuit board layout is critical for Electromagnetic Compat-
ibility (EMC) protection. The following guidelines are
recommended:
The protection device should be placed near the input
terminals or connectors, the device will divert the
transient current immediately before it can be coupled
into the nearby traces.
The path length between the TVS device and the
protected line should be minimized.
All conductive loops including power and ground
loops should be minimized.
The transient current return path to ground should be
kept as short as possible to reduce parasitic induc-
tance.
Ground planes should be used whenever possible.
For multilayer PCBs, use ground vias.
5
6
7
8
GND
GND
USB PORT VBUS
D+
D-
GND
Figure 2. Typical Differential-Mode T1/E1 Protection
RTIP
RRING
4
3
2
1
PTC
PLC01-
6
PTC
5
6
7
8
TTIP
GND
GND
PTC
TRING
PLC01-
6
PTC
05096.R8 3/07
4
www.protekdevices.com

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]