NJ88C33 데이터 시트보기 (PDF) - Zarlink Semiconductor Inc

부품명

상세내역

제조사

NJ88C33

Frequency Synthesiser (I2C BUS Programmable)

Zarlink Semiconductor Inc 

NJ88C33

APPLICATION CIRCUITS

Single Modulus

In this mode, the NJ88C33 synthesiser can be used with

or without a fixed modulus prescaler. The R counter is

programmed with a value to produce a comparison frequency

fc. When the N counter is changed by 1 the loop is no longer

in lock and the phase detector output produces current pulses

to bring the loop back into lock. These pulses are integrated by

the loop fiiter to produce the VCO voltage drive. When the

VCO loop is locked, Fl/N=fC i.e., the VCO frequency is N x fC.

Using a prescaler with a division ratio P, the smallest VCO

output frequency step is Pf and the VCO frequency is PNf .

C

C

If a low pass filter is connected to the lock detect output as

shown and sampled by the microprocessor, the proximity of

the synthesiser loop to lock can be evaluated.

The A counter is not used in this mode.

Fig. 7 Single modulus application

Dual Modulus

This mode allows much higher frequencies to be used in

conjunction with a prescaler but maintains the step size, fc. In

this mode, a dual modulus prescaler (with ratios P and P + 1)

must be used with the NJ88C33. The A counter controls the

MOD output, which is used to select the division ratio of the

prescaler.

When the A counter is non-zero, the MOD output is low and

goes high when the A counter has counted down to zero.

MOD remains high until the N counter reaches zero, when

both counters are re-loaded. Thus, the prescaler divides by P

for N-A cycles and by P + 1 for A cycles of Fl. The VCO

frequency is given by PNfC + AfC.

Note that programming A = 0 produces a count of 128 cycles.

Fig. 8 Dual modulus application

8

Share Link: