LG1625AXF 데이터 시트보기 (PDF) - Agere -> LSI Corporation

부품명

상세내역

제조사

LG1625AXF

Laser Driver

Agere -> LSI Corporation 

LG1625AXF Laser Driver

Data Sheet

June 1999

Handling Precautions

Although protection circuitry has been designed into this device, proper precautions should be taken to avoid expo-

sure to electrostatic discharge (ESD) during handling and mounting. Lucent employs a human-body model (HBM)

and charged-device model (CDM) for ESD-susceptibility testing and protection design evaluation. ESD voltage

thresholds are dependent on the circuit parameters used in the defined model. No industry-wide standard has

been adopted for the CDM. However, a standard HBM (resistance = 1500 Ω, capacitance = 100 pF) is widely used

and, therefore, can be used for comparison purposes. The HBM ESD threshold presented here was obtained by

using these circuit parameters.

Table 3. ESD Threshold Voltage

Human-Body Model ESD Threshold

Device

LG1625AXF

Voltage

≥200 V

Mounting and Connections

Certain precautions must be taken when using solder. For installation using a constant temperature solder, temper-

atures of under 300 °C may be employed for periods of time up to 5 seconds, maximum. For installation with a sol-

dering iron (battery operated or nonswitching only), the soldering tip temperature should not be greater than 300 °C

and the soldering time for each lead must not exceed 5 seconds.

4

Lucent Technologies Inc.

Share Link: