AT88SA10HS-TH-T(2010) 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

제조사

AT88SA10HS-TH-T
(Rev.:2010)

Atmel CryptoAuthentication Host Security Chip

Atmel Corporation 

Atmel AT88SA10HS Host Authentication Chip

4.1.3.

Transmit Flag

The Transmit flag is used to turn around the signal so that the Atmel® AT88SA10HS can send data back to the

system, depending on its current state. The bytes that the AT88SA10HS returns to the system depend on its

current state as follows:

Table 4-3. Return Codes

State Description

Error/Status Description

After Wake, but prior to first

command

0x11

Indication that a proper Wake token has been received by the Atmel

AT88SA10HS

After successful command

execution

–

Return bytes per “Output Parameters” in Command section of this document.

In some cases this is a single byte with a value of 0x00 indicating success.

The Transmit flag can be resent to the Atmel AT88SA10HS repeatedly if a re-

read of the output is necessary

Execution error

0x0F

Command was properly received but could not be executed by the Atmel

AT88SA10HS. Changes in the Atmel AT88SA10HS state or the value of the

command bits must happen before it is re-attempted

After CRC or other

communications error

0xFF

Command was NOT properly received by the Atmel AT88SA10HS and should

be re-issued by the system. No attempt was made to execute the command

The AT88SA10HS always transmits complete blocks to the system, so in the above table, the status/error bytes

result in 4 bytes going to the system – count, error, CRC x 2.

After receipt of a command block, the AT88SA10HS will parse the command for errors, a process which takes

tPARSE (Refer to Section 4.2.2). After this interval the system can send a Transmit token to the AT88SA10HS – if

there was an error, the AT88SA10HS will respond with an error code. If there is no error, the AT88SA10HS

internally transitions automatically from t PARSE to t EXEC and will not respond to any Transmit tokens until both

delays are complete.

4.1.4. Sleep Flag

The sleep flag is used to transition the AT88SA10HS to the low power state, which causes a complete reset of the

AT88SA10HS’s internal command engine and input/output buffer. It can be sent to the AT88SA10HS at any time

when the AT88SA10HS will accept a flag.

To achieve the specified I SLEEP, Atmel recommends that the input signal be brought below VIL when the chip is

asleep. To achieve ISLEEP if the sleep state of the input pin is high, the voltage on the input signal should be within

0.5V of VCC to avoid additional leakage on the input circuit of the chip.

The system must calculate the total time required for all commands to be sent to the AT88SA10HS during a

single session, including any inter-bit/byte delays. If this total time exceeds tWATCHDOG then the system must issue a

partial set of commands, then a Sleep flag, then a Wake token, and finally after the Wake delay, issue the

remaining commands.

9

8595F–SMEM–8/10

Share Link: