Getting Started
1. Carefully remove any ICs in the green “SCKT3200A2” socket.
2. Insert the furnished ATMega88 into the “SCKT3200A2” socket.
Note: The orientation of the red stripe in the cable is not critical in the following steps as long as pin 1 is con-
nected to pin 1.
3. Using a 6-pin jumper cable supplied with the STK500;
connect the two male headers “ISP6PIN” and “SPROG2”.
4. Using a 10-pin jumper cable supplied with the STK500;
connect the two male headers “PORTC” and “LEDS”.
5. Using a 10-pin jumper cable supplied with the STK500;
connect the two male headers “PORTD” and “SWITCHES”.
6. Place jumpers on the following headers as shown in Figure 2-2.
– VTARGET
– AREF
– RESET
– XTAL1
– OSCEL (a 3-pin header. Place a jumper next to the “1” printed on the board).
Figure 2-2. Detail of Jumper Placement on the STK500
2-2
5170C–AVR–10/09
STK512 User Guide