Signal Description
Pin Description
Table 2: Network Interface
88E3016
31
30
Pin Name
MDIP[0]
MDIN[0]
Type
I/O
26
MDIP[1]
I/O
25
MDIN[1]
18
SIGDET
I
Description
Media Dependent Interface[0].
In MDI configuration, MDI[0]± is used for the transmit pair. In MDIX
configuration, MDI[0]± is used for the receive pair.
Media Dependent Interface[1].
In MDI configuration, MDI[1]± is used for the receive pair. In MDIX
configuration, MDI[1]± is used for the transmit pair.
In 100BASE-FX mode, SIGDET indicates whether a signal is
detected by the fiber optic transceiver.
In 100BASE-TX/10BASE-T modes, this pin should not be left
floating. It should be tied either high or low.
Table 3: Serial Management Interface
88E3016 Pin Name
48
MDC
Ty p e
I
45
MDIO
I/O
Description
MDC is the clock reference for the serial management interface. A
continuous clock stream is not required (i.e., MDC can be stopped
when the MDC/MDIO master is not sending a command). The
maximum frequency supported is 8.33 MHz.
MDIO is the management data. MDIO is used to transfer manage-
ment data in and out of the device synchronously to MDC. This pin
requires a pull-up resistor in a range from 1.5 kohm to 10 kohm.
Table 4: LED
88E3016
9
Pin Name
LED[2]/Interrupt
Ty p e
O
8
LED[1]
O
6
LED[0]
O
Description
Parallel LED outputs. See Section 2.11 "LED Interface" on page
33 for LED interface details. See Section 2.2.3 "Programming
Interrupts" on page 20 for interrupt details.
Parallel LED outputs. See Section 2.11 "LED Interface" on page
33 for LED interface details.
Parallel LED outputs. See Section 2.11 "LED Interface" on page
33 for LED interface details.
Copyright © 2008 Marvell
January 4, 2008, Advance
Document Classification: Proprietary Information
Doc. No. MV-S103164-00, Rev. A
Page 11