DS276 데이터 시트보기 (PDF) - Dallas Semiconductor -> Maxim Integrated

부품명

상세내역

제조사

DS276

Low Power Transceiver Chip

Dallas Semiconductor -> Maxim Integrated 

DS276

feet. As a prime example, the DS276 will not meet the RS-232 requirement that the signal levels be at

least ±5 volts minimum when terminated by a 3 kΩ=load and VDRV+ = +3-5 volts. Typically 2.5 to 4 volts

will be present at TXOUT when spacing under this condition, depending on the supply voltage. However,

since most RS-232 receivers will correctly interpret any voltage over 2 volts as a space, there will be no

problem transmitting data.

DS276 BLOCK DIAGRAM Figure 1

APPLICATIONS INFORMATION

The DS276 is designed as a low-cost, RS-232-E interface expressly tailored for the unique requirements

of battery-operated handheld products. As shown in the electrical specifications, the DS276 draws

exceptionally low operating and static current. During normal operation when data from the handheld

system is sent from the TXOUT output, the DS276 only draws significant VDRV+ current when TXOUT

transitions positively (spacing). This current flows primarily into the RS-232 receiver’s 3-7 kΩ=load at

the other end of the attaching cable. When TXOUT is marking (a negative data signal), the VDRV+ current

falls dramatically since the negative voltage is provided by the transmit signal from the other end of the

cable. This represents a large reduction in overall operating current, since typical RS-232 interface chips

use charge-pump circuits to establish both positive and negative levels at the transmit driver output. To

obtain the lowest power consumption from the DS276, observe the following guidelines: First, to

minimize VDRV+ current when connected to an RS-232 port, always maintain TXIN at a logic 1 when data

is not being transmitted (idle state). This will force TXOUT into the marking state, minimizing VDRV+

current. Second, VDRV+ current will drop significantly when VCC is grounded. Therefore, if VDRV+ is

derived independently from VCC (for example connected to a 9V battery), the logic supply voltage can be

turned off to achieve the lowest possible power state.

FULL-DUPLEX OPERATION

The DS276 is intended for full-duplex operation using the full-duplex circuit shown in Figure 4 to

generate a negative rail from RXIN. The 22 µF capacitor forms a negative-charge reservoir; consequently,

when the TXD line RXIN is spacing (positive), TXOUT still has a negative source available for a time

period determined by the capacitor and the load resistance at the other end (3-7 kΩ).

SUPPLY VOLTAGE OPTIONS

The DS276 is intended primarily for use in single supply 3- or 5- volts systems. However, several supply

configurations are possible.

3V OPERATION

The simplest configuration is to use a single 3V supply for VCC and Vdrv+, and connect Vdrv- to ground.

This will result in the lowest power consumption and will give adequate serial communication between

3 of 11

Share Link: