MX867P4 데이터 시트보기 (PDF) - MX-COM Inc
부품명
상세내역
제조사
MX867P4 Datasheet PDF : 42 Pages
| |||
Low Power V.22 Modem
7
CMX867 Advance Information
If the time constant of R24 and C22 is large enough then the voltage on RT will remain below the threshold of
the 'B' Schmitt trigger for the duration of a ring cycle.
The time for the voltage on RT to charge from VSS towards VDD can be derived from the formula
VRT
=
VDD
1
−
e
−t
R24×C22
As the Schmitt trigger high-going input threshold voltage (VtHI) has a minimum value of 0.56 x VDD, then the
Schmitt trigger B output will remain high for a time of at least 0.821 x R24 x C22 following a pulse at RD.
The values of R24 and C22 given in Figure 3 (470kΩ and 0.33µF) give a minimum RT charge time of 100ms,
which is adequate for ring frequencies of 10Hz or above.
Note: The circuit will also respond to a telephone line voltage reversal. If necessary the µC can distinguish
between a Ring signal and a line voltage reversal by measuring the time that bit 14 of the Status Register
(Ring Detect) is high.
If the Ring detect function is not used then pin RD should be connected to VSS and RT to VDD.
3.2 Line Interface
A line interface circuit is needed to provide dc isolation and to terminate the line.
3.2.1 2-Wire Line Interface
Figure 4 shows an interface for use with a 600Ω 2-wire line. The complex line termination is provided by R13
and C10, high frequency noise is attenuated by C10 and C11, while R11 and R12 set the receive signal level
into the modem. For clarity, 2-wire line protection circuits have not been shown.
To Ring
Detect Circuit
See Section 3.1
+ve
2-Wire
Line
Optional buffer if
needed to drive
low resistance relay
1:1
C10
RDRV
RXAFB
R12
R11
C3
R13
C11
RXA
RXA
VBIAS
TXA
-
+
CMX867
TXA
Figure 4: 2-Wireline Interface Circuit
R11
See text
C3
See Figure 2
R12
100kΩ
C10
33nF
R13
600Ω
C11
100pF
Resistors ±5%, capacitors ±20%
Table 4: 2-Wireline Interface Circuit External Components
The transmit line signal level is determined by the voltage swing between the TXA and TXA pins, less 6dB
due to the line termination resistor R13, and less the loss in the line coupling transformer.
2000 MX-COM, Inc.
www.mxcom.com tel: 800 638 5577 336 744 5050 fax: 336 744 5054
Doc. # 20480219.001
4800 Bethania Station Road, Winston-Salem, NC 27105-1201 USA
All trademarks and service marks are held by their respective companies.
Share Link: 