DatasheetQ Logo
Electronic component search and free download site. Transistors,MosFET ,Diode,Integrated circuits

BA1442A 데이터 시트보기 (PDF) - ROHM Semiconductor

부품명
상세내역
제조사
BA1442A
ROHM
ROHM Semiconductor ROHM
BA1442A Datasheet PDF : 17 Pages
First Prev 11 12 13 14 15 16 17
Audio ICs
Pin 9: Forced monaural (SW1)
If the voltage on pin 9 goes to 2.2V or higher in FM mode,
forced monaural operation starts (VCO stops, the stereo
indicator goes off, and audio output goes monaural). Do
not apply a voltage to pin 9 that is higher than the voltage
on pin 3 (VCC). Also, when in AM mode, the AM detector
output is output on pin 9, so use a switch to switch pin 9
open circuit in AM mode, as shown in the application cir-
cuit example. If you change the voltage on pin 9 during
AM operation, the AGC characteristics will be disturbed.
Pin 10: Stereo indicator
The pin 10 current is fixed at 10mA, so an external cur-
rent-limiting resistor is not required. If you wish to reduce
the brightness of the LED, connect a resistor in parallel
to reduce the current. If you do not wish to use stereo in-
dication, connect pin 10 directly to the power supply,
however, the current consumption is that same as that
when stereo indication is used. The withstanding voltage
of pin 10 is 9V, so use caution when connecting it to pow-
er sources other than the IC power supply.
BA1442A
Pin 14: PLL filter (C15, C16, and R4)
PLL loop filter for the MPX. Varying the values of these
components changes the capture range of the PLL, but
can also result in PLL beat, or the PLL going out of lock
due to temperature changes, so do not change these
component values.
Pin 15: Pilot filter and AGC filter (C17)
Pin 15 is used by both the MPX pilot filter and the AM
AGC filter. Lower values for C17 will result in increased
THD for bass-region AM audio, and larger values will in-
crease the time required to switch between monaural
and stereo for FM. Characteristic curves for various val-
ues of C17 are given in Figs. 7 to 9.
Pins 11 and 12
De-emphasis capacitors (C13 and C14)
The output impedance of pins 11 and 12 (5k), and C13
and C14 set the de-emphasis time constant (50µsec. for
0.01µF, and 75µsec. for 0.015µF). Do not connect C13
and C14 if composite (voice multiplex etc.) signal proces-
sing will be performed at the following stage.
Pin 13: AM / FM switching noise reduction filter
Pin 13 is the AM power supply pin. When power is ap-
plied, the circuit is in AM mode. By setting a CR time
constant, it is possible to reduce the audible switching
noise that occurs when switching between AM and FM.
Choose the resistor so that the voltage drop across the
resistor is 0.5V max. with respect to the pin 3 (VCC). Do
not apply a voltage higher than the voltage on pin 3 (VCC)
to pin 13.
347

Share Link: 

datasheetq.com  [ Privacy Policy ]Request Datasheet ] [ Contact Us ]