L93PI 데이터 시트보기 (PDF) - STMicroelectronics
부품명
상세내역
제조사
L93PI Datasheet PDF : 8 Pages
| |||
CIRCUIT DESCRIPTION
The L93PI is a quad low side driver for lines,
lamps or inductive loads in automotive and indus-
trial applications.
All INputs are TTL or CMOS compatible. This al-
lows the device to be driven directly by a micro-
controller. For the noise immunity, all inputs have
a Schmitt-trigger with a hysteresis of typ. 100mV.
Each input stage has an input voltage protection
from -24V to 45V. The device can be activated
with a ’high’ signal on ENable input. ENable ’low’
switches the device into the sleep mode. In this
mode the quiescent current is less than 10µA. A
high signal on PRoGramming input changes the
signal transfer polarity from noninverting into the
inverting mode. Normally this pin is connected to
VS or GND. These pins (PRG and EN) are inter-
nally fixed at low status by open input condition.
Independent of the PRoGramming input, the
OUTput switches off, if the signal INput pin is not
connected.
Each output driver has a current limitation of min
0.4A and a seperate thermal shut-down. The ther-
mal shut-down deactivates that output which ex-
L93PI
ceeds Temperature switch off level. About 20K
below this temperature threshold the output will
be activated again. This means, that each output
is able to sink continuously 285mA without acti-
vating thermal shut-down at 85°C ambient tem-
perature (SO20). The slew rate of the output is
limited to max. 14V/µs to reduce the electromag-
netic interference, but not for the enable transfer
characteristic (see fig. 1). An integrated active fly-
back voltage limitation clamps the output voltage
during the flyback phase of inductive loads to typ.
50V. The power DMOS switches ON, if the device
is enabled and the OUTput swings below ground.
This protection avoids the activation of parasitics
inside the power DMOS.
The DIAGnostic is an open drain output. The logic
status depends on the PRoGramming pin. If the
PRG pin is ’low’ the DIAG output becomes low, if
the device works correctly.
At thermal shut-down of one channel, discon-
nected ground or supply voltage the DIAGnostic
output becomes high. If the PRG pin is ’high’ this
output is switched off at normal function and
switched on at overtemperature.
DIAGNOSTIC TABLE
Pins
EN
Normal function
H
H
H
H
L
Overtemperature,
H
disconnected ground or
supply voltage
Overtemperature
H
PRG
L
L
H
H
X
L
H
X = not relevant * selective for each channel at overtemperature
IN
L
H
L
H
X
X
X
OUT
L (on)
H (off)
H (off)
L (on)
H (off)
H (off) *
H (off) *
DIAG
L (on)
L (on)
H(off)
H(off)
H(off)
H (off)
L (on)
5/8
Share Link: 