A1321, A1322,
and A1323
Ratiometric Linear Hall Effect Sensor ICs
for High-Temperature Operation
DEVICE CHARACTERISTICS1 over operating temperature (TA) range, unless otherwise noted
Characteristic
Symbol
Test Conditions
Min.
Typ.2
Max. Units
Electrical Characteristics; VCC = 5 V, unless otherwise noted
Supply Voltage
Vcc(op)
Operating; Tj < 165°C
Supply Current
Icc
B = 0, Iout = 0
Quiescent Voltage
Vout(q)
B = 0, TA = 25ºC, Iout = 1 mA
Output Voltage3
Vout(H)
Vout(L)
B = +X, Iout = –1 mA
B = –X, Iout = 1 mA
Output Source Current Limit3
Iout(LM)
B = –X, Vout → 0
Supply Zener Clamp Voltage
VZ
Icc = 11 mA = Icc(max) + 3
Output Bandwidth
BW
4.5
–
2.425
–
–
–1.0
6
–
5.0
5.5
V
5.6
8
mA
2.5
2.575
V
4.7
–
V
0.2
–
V
–1.5
–
mA
8.3
–
V
30
–
kHz
Clock Frequency
fC
–
150
–
kHz
Output Characteristics; over VCC range, unless otherwise noted
A1321; Cbypass = 0.1 μF, no load
–
–
40
mV
Noise, Peak-to-Peak4
VN
A1322; Cbypass = 0.1 μF, no load
–
–
25
mV
A1323; Cbypass = 0.1 μF, no load
–
–
20
mV
Output Resistance
Rout
Iout ≤ ±1 mA
–
1.5
3
Ω
Output Load Resistance
RL
Iout ≤ ±1 mA, VOUT to GND
4.7
–
–
kΩ
Output Load Capacitance
CL
VOUT to GND
–
–
10
nF
1 Negative current is defined as conventional current coming out of (sourced from) the specified device terminal.
2 Typical data is at TA = 25°C. They are for initial design estimations only, and assume optimum manufacturing and application
conditions. Performance may vary for individual units, within the specified maximum and minimum limits.
3 In these tests, the vector X is intended to represent positive and negative fields sufficient to swing the output driver between fully OFF
and saturated (ON), respectively. It is NOT intended to indicate a range of linear operation.
4 Noise specification includes both digital and analog noise.
Allegro MicroSystems, Inc.
4
115 Northeast Cutoff
Worcester, Massachusetts 01615-0036 U.S.A.
1.508.853.5000; www.allegromicro.com