OMR1033NM 데이터 시트보기 (PDF) - Omnirel Corp => IRF
부품명
상세내역
제조사
OMR1033NM Datasheet PDF : 6 Pages
| |||
OMR1033SR, OMR1033ST, OMR1033NM
OMNIREL’S RADIATION TEST PROCEDURE
Note: Sample die from each wafer were tested at each kRAD increment shown above.
•
Radiation Testing is performed on a single wafer by wafer basis.
•
Each wafer is identified and a random sample of 5 die per wafer is selected.
•
The die are then individually assembled in a hermetic package, data logged,
electrically tested, hi-rel screened and then submitted to radiation testing.
•
The packaged die are submitted to Steady State Total Dose radiation per
Method 1019, Condition A at a dose rate of 50 RAD/sec biased at maximum
supply voltage.
•
Final electrical test is performed within two hours of Total Dose Radiation level
from a Cobalt 60 source and 168 hr, 100°C annealing process.
Read and record data including two non-radiated control samples.
•
The wafer is then qualified only if samples from wafers meet full electrical
specifications after 150% of total dose rating as specified in each product data sheet.
•
Omnirel’s controlling specifications are as follows: For Voltage Regulators the controlling
specification is MIL-PRF-38534/MIL-STD-883.
AVAILABLE PRODUCT SCREENING
Screen
Standard Class Level Screening
MIL-PRF-38535
Level B*
Level S*
Test Method Required Test Method Required
Wafer Lot Acceptance
Non-destructive Bond Pull
Pre-Cap Visual Inspection
Temperature Cycle
Constant Acceleration
Visual Inspection
PIND Test
Serialization
Pre-Burn-In Electrical
Burn-In
Interim Electrical
PDA Calculations
Final Electrical
Fine & Gross Seal
Radiographic
**Conformance Inspection
Final Visual Inspection
-----
-----
2010
1010
2001
-----
-----
-----
Data Sheet
1015/160 hrs.
-----
5% Functional
Data Sheet
1014
-----
GR A
2009
-----
-----
100%
100%
100%
100%
-----
-----
100%
100%
-----
Lot
100%
100%
-----
100%
Sample
5007
-----
2010
1010
2001
-----
2020
-----
Data Sheet
1015/240hrs.
Data Sheet
5% Functional
Data Sheet
1014
2012/Two Views
GR A
2009
100%
-----
100%
100%
100%
100%
100%
100%
100%
100%
100%
Lot
100%
100%
100%
100%
Sample
* For “B” Level Screening add “M” to part number, for “S” Level Screening add “S” to part
number, see part number designator.
**Additional conformance inspection testing, i.e. Group B, C, & D optional.
Share Link: 