89C51CC03UA-ZM 데이터 시트보기 (PDF) - Atmel Corporation

부품명

상세내역

제조사

89C51CC03UA-ZM

Enhanced 8-bit MCU with CAN Controller and Flash Memory

Atmel Corporation 

AT89C51CC03

Pin Name

P3.0:7

P4.0:4

Type Description

I/O Port 3:

Is an 8-bit bi-directional I/O port with internal pull-ups. Port 3 pins that have 1’s written to them are pulled high by the internal

pull-up transistors and can be used as inputs in this state. As inputs, Port 3 pins that are being pulled low externally will be a

source of current (IIL, see section "Electrical Characteristic") because of the internal pull-ups.

The output latch corresponding to a secondary function must be programmed to one for that function to operate (except for

TxD and WR). The secondary functions are assigned to the pins of port 3 as follows:

P3.0/RxD:

Receiver data input (asynchronous) or data input/output (synchronous) of the serial interface

P3.1/TxD:

Transmitter data output (asynchronous) or clock output (synchronous) of the serial interface

P3.2/INT0:

External interrupt 0 input/timer 0 gate control input

P3.3/INT1:

External interrupt 1 input/timer 1 gate control input

P3.4/T0:

Timer 0 counter input

P3.5/T1/SS:

Timer 1 counter input

SPI Slave Select

P3.6/WR:

External Data Memory write strobe; latches the data byte from port 0 into the external data memory

P3.7/RD:

External Data Memory read strobe; Enables the external data memory.

It can drive CMOS inputs without external pull-ups.

I/O Port 4:

Is an 2-bit bi-directional I/O port with internal pull-ups. Port 4 pins that have 1’s written to them are pulled high by the internal

pull-ups and can be used as inputs in this state. As inputs, Port 4 pins that are being pulled low externally will be a source of

current (IIL, on the datasheet) because of the internal pull-up transistor.

The output latch corresponding to a secondary function RxDC must be programmed to one for that function to operate. The

secondary functions are assigned to the two pins of port 4 as follows:

P4.0/TxDC:

Transmitter output of CAN controller

P4.1/RxDC:

Receiver input of CAN controller.

P4.2/MISO:

Master Input Slave Output of SPI controller

P4.3/SCK:

Serial Clock of SPI controller

P4.4/MOSI:

Master Ouput Slave Input of SPI controller

It can drive CMOS inputs without external pull-ups.

7

4182K–CAN–05/06

Share Link: