OPI1290 데이터 시트보기 (PDF) - TT Electronics.
부품명
상세내역
제조사
OPI1290 Datasheet PDF : 2 Pages
| |||
Fiber Optic Isolator - Photologic®
Sensor
Absolute Maximum Ratings (TA=25°C unless otherwise noted)
Storage Temperature Range (note 3)
Operating Temperature Range (note 3)
Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron]
Power Dissipation (2)
-40o C to +80o C
-20° C to +75° C
260° C(1)
100 mW
Electrical Characteristics (TA = 25°C unless otherwise noted)
SYMBOL
PARAMETER
MIN TYP
LED (See OP240 for additional information)
VF
On-State Collector Current
IR
Collector-Dark Current
1.2 -
-
-
MAX
2.3
80
UNITS
V IF = 20 mA
µA VR = 3.0 V
TEST CONDITIONS
Photologic® Sensor (See OP550 for additional information)
SYMBOL
PARAMETER
VCC
ICC
EeT(+)
EeT(+)/EeT(-)
VOH
VOL
Operating Supply Voltage
Peak-to-Peak VCC Ripple Necessary to Cause
False Triggering of Output
Supply Current(4)
Positive-Going Threshold Irradiance(2)
Hysteresis Ratio
Operating Supply Voltage
Low Level Output Voltage
IOS
Short Circuit Output Current
IOH
High Level Output Current(2)
TR & TF Output Rise & Fall Time
tpEeT(+) Propagation Delay Positive–Going
tpEeT(-) Propagation Delay Negative–Going
tPLH, TPHL Propagation Delay (Low-High/High-Low)
MIN TYP MAX UNITS
4.5 - 16
V
TEST CONDITIONS
-
-
-
2
V VCC = 5 V DC, f = DC to 50 MHz
-
8 15
mA EE = 0 or 3 mW/cm2, VCC = 5.5 V
.25
-
2.4 mW/cm2 VCC = 5 V, TA = 25° C
1.50 2 2.5
-
-
2.1
-
-
V
IOH = -1 µA, EE = 1 mW/cm2
- 0.25 0.4
V VCC = 4.5 V, IOL = 12.8 mA, EE = 0
-20
-55 -100
mA
VCC = 5.5 V, Output = GND,
EE = 3 mW/cm2
-
1 100
µA
VCC = 4.5 V, VOH = 30 V,
EE = 3 mW/cm2
VCC = 5 V, TA = 25° C, EE = 0 or 3 mW/
-
25 70
ns cm2, f = 10 kHz, DC = 50%
RL = 8 TTL loads
VCC = 5 V, TA = 25° C,
-
2.5 5.0
µs EE = 0 or 3 mW/cm2, RL = 8 TTL loads, f
= 10 kHz, DC = 50%
-
2.5 5.0
µs
VCC = 5 V, TA = 25° C, EE = 0 or 3 mW/
cm2, RL = 360 Ω, f = 10 kHz, DC = 50%
- 5.0 -
µs DC = 50%, RL = 10 TTL Loads
Notes:
(1)
(2)
(3)
Derate linearly 2.5 mW/° C above 25° C for all devices in the OPL550, OPL551, OPL560, OPL561, OPL562 and OPL563 series.
Irradiance measurements are made with λi = 935 nm.
Storage and Operating temperature values are based on the plastic optical interface temperature ratings. Please reference UL1577 and UL file AVLVZ.E89328
General Note
TT Electronics reserves the right to make changes in product specification without
notice or liability. All information is subject to TT Electronics’ own data and is
considered accurate at time of going to print.
© TT electronics plc
TT Electronics | OPTEK Technology
1645 Wallace Drive, Carrollton, TX 75006|Ph: +1 972 323 2200
www.ttelectronics.com | www.optekinc.com
Issue A 09/2016 Page 2
Share Link: 