LM2576HVT-12 데이터 시트보기 (PDF) - Unspecified

부품명

상세내역

제조사

LM2576HVT-12

SIMPLE SWITCHER® 3A Step-Down Voltage Regulator

Unspecified 

LM2576/LM2576HV

Note 1: Absolute maximum Ratings indicate limits beyond which damage to the device may occur. Operating Ratings indicate conditions for which the

device is intended to be functional, but do not guarantee specific performance limits. For guaranteed specifications and test conditions, see the

Electrical Characteristics.

Note 2: All limits guaranteed at room temperature (standard type face) and at temperature extremes (bold type face). All room temperature limits are

100% production tested. All limits at temperature extremes are guaranteed via correlation using standard Statistical Quality Control (SQC) methods.

Note 3: External components such as the catch diode, inductor, input and output capacitors can affect switching regulator system performance. When

the Lm2576/LM2576HV is used as shown in the Figure 2 test circuit, system performance will be as shown in system parameters section of Electrical

Characteristics.

Note 4: Output pin sourcing current. No diode , inductor or capacitor connected to output.

Note 5: Feedback pin removed from output and connected to 0V.

Note 6: Feedback pin removed from output and connected to +12V for the Adjustable, 3.3V, and 5V versions, and +25V for the 12V and 15V versions,

to force the output transistor OFF.

Note 7: VIN=40V (60V for high voltage version).

Note 8: Junction to ambient thermal resistance (no external heat sink) for the 5 lead TO-220 package mounted vertically, with 1/2 inch leads in a socket,

or on a PC board with minimum copper area.

Note 9: Junction to ambient thermal resistance (no external heat sink) for the 5 lead TO-220 package mounted vertically, with 1/4 inch leads soldered to

a PC board containing approximately 4 square inches of copper area surrounding the leads.

Note 10: If the TO-263 package is used, the thermal resistance can be reduced by increasing the PC board copper area thermally connected to the

package. Using 0.5 square inches of copper area,

square inches of copper area, JA is 32℃/W.

JA is 50℃/W, with 1 square inch of copper area,

JA is 37℃/W, and with 1.6 or more

Note 11: The oscillator frequency reduces to approximately 11KHz in the event of and output short or an overload which causes the regulated output

voltage to drop approximately 40% from the nominal output voltage. This self protection feature lowers the average power dissipation of the IC by

lowering the minimum duty cycle from 5% down to approximately 2%.

Typical Performance Characteristics

(Circuit of Figure 2)

www.artschip.com

6

Share Link: