MAX44261 데이터 시트보기 (PDF) - Maxim Integrated

부품명

상세내역

제조사

MAX44261

1.8V, 15MHz Low-Offset, Low-Power, Rail-to-Rail I/O Op Amps

Maxim Integrated 

MAX44259/MAX44260/

MAX44261/MAX44263

1.8V, 15MHz Low-Offset,

Low-Power, Rail-to-Rail I/O Op Amps

Applications Information

Power-Up Autotrim

The ICs feature an automatic trim that self-calibrates the

VOS of these devices to less than 50µV of input offset

voltage on power-up. This self-calibration feature allows

the device to eliminate input offset voltage effects due

to power supply and operating temperature variation

simply by cycling its power. The autotrim sequence takes

approximately 10ms to complete and is triggered by an

internal power-on-reset (POR) circuitry. During this time,

the inputs and outputs are put into high impedance and

left unconnected. The MAX44261 can also be forced into

a self-calibration cycle by pulling the CAL input low for

1µs. This input also puts the part into shutdown mode.

Shutdown Operation

The MAX44260 features an active-low shutdown mode

that puts both inputs and outputs into high impedance

and substantially lowers the quiescent current to less

than 1FA. Putting the output into high impedance allows

multiple outputs to be multiplexed onto a single output

line without the additional external buffers. The device

does not self-calibrate when exiting shutdown mode

and retains its power-up trim settings. Figure 3 shows that

the device also recovers from shutdown in under 30Fs.

The MAX44261 features a recalibrate input that acts the

same as the shutdown mode of the MAX44260. However,

when the input is pulled low, the device goes through a

self-calibration sequence again (Figure 3).

The shutdown logic levels of the devices are independent

of supply, allowing the shutdown feature of the device to

operate off of a 1.8V or 3.3V microcontroller, regardless

of supply voltage.

Rail-to-Rail Input/Output

The input voltage range of the ICs extends 100mV above

VDD and below VSS. The wide input common-mode volt-

age range allows the op amp to be used as a buffer and

as a differential amplifier in a wide-variety of signal pro-

cessing applications. Output voltage high/low is designed

to be only 50mV above VSS and below VDD allowing

maximum dynamic range in single-supply applications.

The high output current and capacitance drive capability

of the devices make them ideal as an ADC driver and a

line driver.

Figure 3

VDD

VSHDN/VCAL

0V

VDD/2

MAX44260

OUTPUT

0V

VDD/2

MAX44261

OUTPUT

0V

30µs

Figure 3. CAL vs. SHDN Input Operation

www.maximintegrated.com

FAST RECOVERY

AMPLIFIER

ACTIVE

AUTOTRIM

SEQUENCE

10ms

RECALIBRATED

AMPLIFIER

ACTIVE

Maxim Integrated │  11

Share Link: