S-24C256C 데이터 시트보기 (PDF) - Seiko Instruments Inc

부품명

상세내역

제조사

S-24C256C

2-WIRE SERIAL E2PROM

Seiko Instruments Inc 

2-WIRE SERIAL E2PROM

S-24C256C

Rev.2.0_02_S

 Pin Functions

1. A0, A1 and A2 (Slave address input) pins

In the S-24C256C, to set the slave address, connect each pin of A0, A1, A2 to GND or VCC. Therefore the users can

set 8 types of slave address by a combination of A0, A1, A2 pins.

Comparing the slave address transmitted from the master device and one that you set, makes possible to select the

S-24C256C from other devices connected onto the bus.

Each A0, A1 and A2 pin has a pull-down resistor. In open, these pins have the status when they are connected to

GND.

2. SDA (Serial data input / output) pin

The SDA pin is used for the bi-directional transmission of serial data. This pin is a signal input pin, and an Nch open

drain output pin.

In use, generally, connect the SDA line to any other device which has the open-drain or open-collector output with

Wired-OR connection by pulling up to VCC by a resistor (Figure 7 shows the relation with an output load).

3. SCL (Serial clock input) pin

The SCL pin is used for the serial clock input. Since the signals are processed at a rising or falling edge of the SCL

clock, pay attention to the rising and falling time and comply with the specification.

4. WP (Write protect input) pin

The write protect is enabled by connecting the WP pin to VCC. When not using the write protect, connect this pin to

GND or set in open.

20

18

16

14

12

Maximum value of pull-up resistor 10

[kΩ]

8

fSCL= 400 kHz

6

4

2

fSCL= 1000 kHz

0

10

100 200

Value of load capacity

[pF]

Figure 7 Output Load

 Initial Shipment Data

Initial shipment data of all addresses is “FFh”.

8

Share Link: