SK100EL11WD 데이터 시트보기 (PDF) - Semtech Corporation
부품명
상세내역
제조사
SK100EL11WD Datasheet PDF : 6 Pages
| |||
SK10/100EL11W
HIGH-PERFORMANCE PRODUCTS
AC Characteristics (continued)
Notes:
1. 10EL circuits are designed to meet the DC specifications shown in the table after thermal
equilibrium has been established. The circuit is in a test socket or mounted on a printed circuit
board and transverse airflow greater than 500 lfpm is maintained. Outputs are terminated through
a 50Ω resistor to VCC -2.0V except where otherwise specified on the individual data sheets.
2. 100K circuits are designed to meet the DC specifications shown in the table where transverse
airflow greater than 500 lfpm is maintained.
3. Within-device skew defined as identical transitions on similar paths through a device.
4. Duty cycle skew is the difference between a TPLH and TPHL propagation delay through a device.
5. Minimum input swing for which AC parameters guaranteed.
6. CMR range is referenced to the most positive side of the differential input signal. Normal operation is
obtained if the high level falls within the specified range and the peak-to-peak voltage lies between
VPP(min) and 1V. The lower end of the CMR range varies 1:1 with VEE and is equal to VEE + 1.6V.
7. For standard ECL DC specifications, refer to the ECL Logic Family Standard DC Specifications Data
Sheet.
8. For part ordering descriptions, see HPP Part Ordering Information Data Sheet.
Application Notes
AN1003 - Termination Techniques for ECL / LVECL / PECL / LVPECL Devices
AN1004 - Interfacing Between LVDS and ECL / LVECL / PECL / LVPECL
AN1005 - Using ECL / LVECL Devices as PECL / LVPECL
AN1006 - Designing with 10K and 100K ECL / PECL Devices
Ordering Information
Ordering Code
SK10EL11WD
SK10EL11WDT
SK100EL11WD
SK100EL11WDT
SK10EL11WMS
SK10EL11WMST
SK100EL11WMS
SK100EL11WMST
SK10EL11WU
SK100EL11WU
Package ID
8-SOIC
8-SOIC
8-SOIC
8-SOIC
8-MSOP
8-MSOP
8-MSOP
8-MSOP
Die
Die
Revision 4/July 18, 2002
5
www.semtech.com
Share Link: 