LH28F800BGB-BL85 데이터 시트보기 (PDF) - Sharp Electronics
부품명
상세내역
제조사
LH28F800BGB-BL85 Datasheet PDF : 43 Pages
| |||
LH28F800BG-L/BGH-L (FOR TSOP, CSP)
Start
Write 40H or 10H,
Address
Write Word
Data and Address
Read
Status Register
0
SR.7 =
1
BUS
OPERATION COMMAND
COMMENTS
Write
Setup Data = 40H or 10H
Word Write Addr = Location to be Written
Write
Word Write
Data = Data to be Written
Addr = Location to be Written
Read
Status Register Data
Suspend Word
No
Write Loop
Suspend
Word Write Yes
Standby
Check SR.7
1 = WSM Ready
0 = WSM Busy
Repeat for subsequent word writes.
SR full status check can be done after each word write or after
a sequence of word writes.
Write FFH after the last word write operation to place device
in read array mode.
Full Status
Check if Desired
Word Write
Complete
FULL STATUS CHECK PROCEDURE
Read Status Register
Data (See Above)
1
SR.3 =
0
VPP Range Error
SR.1 = 1
0
Device Protect Error
1
SR.4 =
0
Word Write
Successful
Word Write Error
BUS
OPERATION COMMAND
COMMENTS
Standby
Check SR.3
1 = VPP Error Detect
Standby
Check SR.1
1 = Device Protect Detect
Standby
Check SR.4
1 = Data Write Error
SR.4, SR.3 and SR.1 are only cleared by the Clear Status
Register command in cases where multiple locations are
written before full status is checked.
If error is detected, clear the status register before attempting
retry or other error recovery.
Fig. 4 Automated Word Write Flowchart
- 17 -
Share Link: 